弯扭管道引起的旋涡畸变对离心压气机气动性能的影响

推进技术 ›› 2017, Vol. 38 ›› Issue (6): 1259-1269.

弯扭管道引起的旋涡畸变对离心压气机气动性能的影响

王磊磊¹,侯红娟¹,马玥珺¹,杨策²,李延昭³

河北工程大学机械与装备工程学院，河北邯郸 056038,河北工程大学机械与装备工程学院，河北邯郸 056038,河北工程大学机械与装备工程学院，河北邯郸 056038,北京理工大学机械与车辆学院，北京 100081,康跃科技股份有限公司，山东寿光 262711

发布日期:2021-08-15
作者简介:王磊磊，男，博士，讲师，研究领域为叶轮机械与增压技术领域。E-mail: wangll@hebeu.edu.cn 通讯作者:侯红娟，女，硕士，讲师，研究领域为车辆内燃机设计技术领域。
基金资助:
河北省自然基金(E2017402135)；河北省高校科研重点项目(ZD2016095)；邯郸市科技研发项目

Effects of Swirl Distortion Induced by Bent-Torsion Ducts on Aerodynamic Performance of a Centrifugal Compressor

College of Mechanical and Equipment Engineering，Hebei University of Engineering，Handan 056038，China,College of Mechanical and Equipment Engineering，Hebei University of Engineering，Handan 056038，China,College of Mechanical and Equipment Engineering，Hebei University of Engineering，Handan 056038，China,School of Mechanical Engineering，Beijing Institute of Technology，Beijing 100081，China and Kangyue Technology Co.，Ltd，Shouguang 262711，China

Published:2021-08-15

摘要/Abstract

摘要： 为了研究弯扭管道进气产生的旋涡畸变对离心压气机气动性能产生的影响，采用数值模拟及实验的方法进行研究。首先明确了管道出口截面二次流场结构随扭转角度的演化过程，发现随管道扭转角度增大，旋涡结构在孪生涡和偏置涡之间变化；当扭转角度等于90°时，管道出口近似呈现团涡结构。研究表明，与孪生涡相比，近似团涡的旋涡形式对压气机性能的影响更显著。在设计转速下，当近似团涡的旋涡方向与叶轮转动方向相同时，压气机压比和效率的下降量约达25%，并减小了喘振流量；而旋涡方向与叶轮转动方向相反时，压气机性能无明显变化，喘振流量同时增大。通过阐述不同叶高气流旋涡角度、旋涡强度与相对气流角之间的关联关系，发现叶轮进口气流旋涡在不同叶高位置上的旋涡角度和强度改变了叶片前缘相对气流角，进而对进气攻角产生明显作用。

关键词: 弯扭管道；离心压气机；旋涡畸变；相对气流角

Abstract: In order to investigate the effects of the swirl distortion induced by the bent-torsion intake duct on the aerodynamic performance of a centrifugal compressor，the numerical and experimental methods were carried out. The evolution processe of the outlet secondary flow structure with the torsional angle is clarified firstly. It is found that the swril form changes between the twin swirl and the offset swirl as the torsion angle increases. The bulk swirl appears approximately at the duct outlet when the torsion angle equals to 90°. Compared with the twin swirl，the shape of bulk swirl produces more obvious effects on the compressor performance. When the bulk swirl has the same rotational direction with the impeller at the design speed，both the pressure ratio and the efficiency decreases about 25%，and the surge flow also decreases. But when the bulk swirl has the opposite rotational direction with the impeller，the compressor performance has no obvious change and the compressor surge flow increases. The relationship among the swril angle，the swirl intensity and the relative flow angle of the blade at different span are investigated in details. The results indicate that both the angle and intensity of the swirl at the impeller inlet in different spans vary the relative flow angle of the blade leading edge and have significant effects on the intake attack angle.

Key words: Bent-torsion duct；Centrifugal compressor；Swirl distortion；Relative flow angle

王磊磊,侯红娟,马玥珺,杨策,李延昭. 弯扭管道引起的旋涡畸变对离心压气机气动性能的影响[J]. 推进技术, 2017, 38(6): 1259-1269.

WANG Lei-lei¹,HOU Hong-juan¹,MA Yue-jun¹,YANG Ce²,LI Yan-zhao³. Effects of Swirl Distortion Induced by Bent-Torsion Ducts on Aerodynamic Performance of a Centrifugal Compressor[J]. Journal of Propulsion Technology, 2017, 38(6): 1259-1269.

参考文献

[1] Ariga I, Kasai N, Masuda S, et al. The Effect of Inlet Distortion on the Performance Characteristics of a Centrifugal Compressor[J]. Journal of Engineering for Gas Turbines and Power, 1983, 105(2): 223-230.
[2] 乔渭阳, 蔡元虎. 畸变进气下压气机叶片非定常载荷的数值模拟[J]. 推进技术, 2001, 22(5): 392-396. (QIAO Wei-yang, CAI Yuan-hu. Numerical Modeling of the Unsteady Aerodynamic Loads in Axial Flow Compressor with Inlet Distortions [J]. Journal of Propulsion Technology, 2001, 22(5): 392-396.)
[3] Zemp Armin, Kammerer Albert, Abhari Reza S. Unsteady CFD Investigation on Inlet Distortion in a Centrifugal Compressor[R]. ASME GT2008-50744.
[4] Kammerer Albert, Abhari Reza S. Blade Forcing Function and Aerodynamic Work Measurements in a High Speed Centrifugal Compressor with Inlet Distortion[J]. Journal of Engineering for Gas Turbines and Power, 2010, 132(9): 559-572.
[5] Kim Yunbae, Engeda Abraham, Aungier Ron, et al. The Influence of Inlet Flow Distortion on the Performance of a Centrifugal Compressor and the Development of an Improved Inlet Using Numerical Simulations[J]. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2001, 215(3): 323-338.
[6] 周颂东, 温泉. 进口总压径向畸变对离心压气机性能的影响[J]. 燃气涡轮试验与研究, 2005, 18(3): 10-14.
[7] 周颂东. 五种径向扩压器与同一离心压气机叶轮相互匹配的试验研究[J]. 燃气涡轮试验与研究, 2005, 18(1): 21-26.
[8] 李杜, 杨策, 陈山, 等. 带90°弯管的离心压气机进口畸变数值研究[J]. 航空动力学报, 2010, 25(11): 2556-2563.
[9] 李杜, 杨策, 陈山, 等. 离心压气机弯管进口畸变非定常特性[J]. 内燃机学报, 2011, 29(5): 468-474.
[10] Li Du, Yang Ce, Zhou Mi, et al. Numerical and Experimental Research on Different Inlet Configurations of High Speed Centrifugal Compressor[J]. Science China Technological Sciences, 2012, 55(1): 174-181.
[11] Wang Leilei, Yang Ce, Zhao Ben, et al. The Change of the Inlet Geometry of a Centrifugal Compressor Stage and Its Influence on the Compressor Performance[J]. Journal of Thermal Science, 2013, 22(3): 197-208.
[12] SAE. A Methodology for Assessing Inlet Swirl Distortion[R]. AIR-5686, 2010.
[13] 胡伟波, 程邦勤, 陈志敏, 等. 整体涡旋流畸变对压气机性能影响的研究[J]. 推进技术, 2015, 36(9): 1324-1330. (HU Wei-bo, CHENG Bang-qin, CHEN Zhi-min, et al. Investigation on Effects of Bulk Swirl Distortion on Compressor Performance[J]. Journal of Propulsion Technology, 2015, 36(9): 1324-1330.)
[14] 康顺, 刘强, 祁明旭. 一个高压比离心叶轮的 CFD 结果确认[J]. 工程热物理学报, 2005, 26(3): 400-404.
[15] LI Du, YANG Ce, ZHOU Me, et al. Simulation of Volute Tongue of Small-Size Centrifugal Compressor[J]. Journal of Beijing Institute of Technology, 2011, 20(4): 496-501.
[16] 侯红娟, 王磊磊, 杨策, 等. 离心压气机非轴对称流动特性分析[J]. 推进技术, 2017, 38(1). (HOU Hong-juan, WANG Lei-lei, YANG Ce, et al. Non-Axisymmetric Flow Characteristics in Centrifugal Compressor[J]. Journal of Propulsion Technology, 2017, 38(1).)
[17] Wang Leilei, Lao Dazhong, Liu Yixiong, et al. Non-Axisymmetric Flow Characteristics in Centrifugal Compressor Revision. [J]. Journal of Thermal Science, 2015, 24(4): 313-322.
[18] 王磊磊, 老大中, 刘恒, 等. 180°进气弯管安装角度对离心压气机的性能影响[J]. 工程热物理学报, 2014, 35(9): 1717-1721.　　　　　　　　　　　　*　收稿日期:2016-01-23；修订日期:2016-04-05。基金项目:河北省自然基金(E2017402135)；河北省高校科研重点项目(ZD2016095)；邯郸市科技研发项目 (1621212047-2)。作者简介:王磊磊,男,博士,讲师,研究领域为叶轮机械与增压技术领域。E-mail: wangll@hebeu.edu.cn通讯作者:侯红娟,女,硕士,讲师,研究领域为车辆内燃机设计技术领域。E-mail: houhongjuan@hebeu.edu.cn(编辑:朱立影)