被动射流旋涡对高速扩压叶栅气动性能的影响

推进技术 ›› 2017, Vol. 38 ›› Issue (6): 1270-1277.

被动射流旋涡对高速扩压叶栅气动性能的影响

王若玉,刘华坪,张东飞,卢炳潇,陈浮,宋彦萍

哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001

发布日期:2021-08-15
作者简介:王若玉，女，硕士生，研究领域为叶轮机械流动机理及控制。E-mail: wry392003711@gmail.com 通讯作者:刘华坪，男，博士，讲师，研究领域为叶轮机械流动机理及控制。
基金资助:
国家自然科学基金(51306042)。

Effects of Passive Vortex Generator Jet on Aerodynamic Performance of a High-Speed Compressor Cascade

School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China,School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China,School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China,School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China,School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China and School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China

Published:2021-08-15

摘要/Abstract

摘要： 提出了一种利用压力面与吸力面间压差产生射流旋涡的被动流动控制技术以改善压气机叶栅的气动性能，在进口马赫数Ma=0.67的高速扩压叶栅上验证了其有效性。结果表明，射流旋涡可有效增强吸力面附面层与主流间的能量交换，改变下游壁面涡的结构和尺寸，推迟流动分离，减小角区损失。当射流距分离线或端壁较近时，当地较厚的附面层使得旋涡上洗区的掺混损失增加；而射流距分离线或端壁过远时均会减弱下洗区能量注入对角区低能流体的影响；指向端壁的射流会增加壁面涡强度，而沿远离端壁方向过大的偏角则会减弱射流旋涡强度，从而减弱其控制效果。当射流轴向距叶片前缘[xj/cx]=40%、沿叶高距端壁h/H=15%、射流偏角β=60°时，其改善栅内流动的效果最佳，总压损失减小可达5.2%，而射流流量仅相当于主流的0.27‰。

关键词: 被动射流旋涡；高速扩压叶栅；气动性能；总压损失

Abstract: To improve the aerodynamic performance of compressor cascades，a flow control technique using the pressure difference between the pressure surface and the suction surface to generate passive vortex generator jet (PVGJ) is proposed，and the effectiveness of the method is validated on a high-speed compressor cascade at Ma=0.67. Results show that the vortex jet is able to strengthen momentum exchange between the boundary layer and the main flow and to change the structure and size of wall vortex significantly. As a result，the separation line is shifted downstream and the loss is decreased. It is found that jets close to the separation line or the end-wall would increase the mixing losses in the up-washed side of the vortex because of the thick boundary layer in these areas. Besides，an excessive distance between the jet and the end-wall would decrease the effect of momentum transition in the down-washed side on the low energy fluid in the corner region. As for the effect of the skew angle，jets pointing towards the end-wall would strengthen the wall vortex while jets with too large skew angles would reduce the induced vortex，thus weakening the performance of PVGJ on the loss reduction. The optimum jet location is around 40% axial chord length and 15% blade height with a skew angle of 60°. The maximum total pressure loss reduction is up to 5.2%，whereas the jet-to-inflow mass flow rate is only 0.27‰.

Key words: Passive vortex generator jet；High-speed compressor cascade；Aerodynamic performance；Total pressure loss

王若玉,刘华坪,张东飞,卢炳潇,陈浮,宋彦萍. 被动射流旋涡对高速扩压叶栅气动性能的影响[J]. 推进技术, 2017, 38(6): 1270-1277.

WANG Ruo-yu,LIU Hua-ping,ZHANG Dong-fei,LU Bing-xiao,CHEN Fu,SONG Yan-ping. Effects of Passive Vortex Generator Jet on Aerodynamic Performance of a High-Speed Compressor Cascade[J]. Journal of Propulsion Technology, 2017, 38(6): 1270-1277.

参考文献

[1] 特雷申科 Ю M. 压气机叶栅的空气动力学[M]. 徐家驹, 译. 北京: 机械工业出版社, 1985.
[2] 徐大懋. 压气机弦向缝隙叶栅的研究[M]. 哈尔滨:哈尔滨汽轮机厂研究所, 1980.
[3] SONG Yan-ping, CHEN Huan-long, CHEN Fu, et al. Effects of Air Injection on Performance of Highly-Loaded Compressor Cascades[R]. ASME 2007-GT-27062.
[4] 冯冬民, 陈浮, 陈焕龙, 等. 孔隙射流结构对扩压叶栅出口流场特性的影响[J]. 航空动力学报, 2009, 24(6): 1364-1371.
[5] 冯冬民, 陈浮, 陈焕龙, 等. 变攻角下孔隙射流对高负荷扩压叶栅气动性能的影响[J]. 燃气涡轮试验与研究, 2010, (1): 9-14.
[6] 陈浮, 陈焕龙, 冯冬民. 高负荷缝隙弯曲扩压叶栅尾迹特性实验[J]. 推进技术, 2009, 30(2): 197-201. (CHEN Fu, CHEN Huan-long, FENG Dong-min. Experimental on Wake Characteristics in Compound Lean Compressor Cascades with Slots Injection [J]. Journal of Propulsion Technology, 2009, 30(2): 197-201.)
[7] 周敏, 王如根, 张相毅, 等. 改变开孔位置对风扇叶片气动特性的影响[J]. 汽轮机技术, 2007, 49(5): 359-361.
[8] 周敏, 王如根, 曾令君, 等. 槽道宽度对压气机叶栅气动性能的影响[J]. 航空动力学报, 2008, 23(6): 1077-1081.
[9] Culley D E, Bright M M, Prahst P S, et al. Active Flow Separation Control of a Stator Vane Using Surface Injection in a Multistage Compressor Experiment[R]. ASME 2003-GT-38863.
[10] Wiederhold O, Hecklau M, King R, et al. Multivariable Control in a Critically Loaded Compressor Cascade [J]. International Journal of Flow Control, 2011, 2(4): 219-236.
[11] Zander V, Nitsche W. Control of Secondary Flow Structures on a Highly Loaded Compressor Cascade[J]. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2013, 227(6): 674-682.
[12] Evans S, Hodson H, Hynes T, et al. Controlling Separation on a Simulated Compressor Blade Using Vortex-Generator Jets[J]. Journal of Propulsion and Power, 2010, 26(4): 819-827.
[13] 刘华坪, 陈焕龙, 李德雄, 等. 射流旋涡发生器控制大折转角扩压叶栅二次流[J]. 航空动力学报, 2015, 30(4): 838-845.
[14] 冯岩岩, 宋彦萍, 刘华坪, 等. 不同攻角下端壁射流旋涡控制扩压叶栅分离流动研究[J]. 推进技术, 2015, 36(1): 54-60. (FENG Yan-yan, SONG Yan-ping, LIU Hua-ping, et al. Effects of End-Wall Vortex Generator Jet on Flow Separation Control in Compressor Cascade under Different Angles of Attack[J]. Journal of Propulsion Technology, 2015, 36(1): 54-60.)
[15] Hergt A, Robert M, Karsten L, et al. A New Approach for Compressor Endwall Contouring [R]. ASME 2011-GT-45858.
[16] 茅晓晨, 刘波, 曹志远, 等. 端壁射流对压气机叶栅角区分离控制的研究[J]. 推进技术, 2014, 35(12): 1615-1622. (MAO Xiao-chen, LIU Bo, CAO Zhi-yuan, et al. Research on Corner Separation Control for Compressor Cascade with End-Wall Jet Flow [J]. Journal of Propulsion Technology, 2014, 35(12): 1615-1622.)
[17] Evans S, Coull J, Haneef I, et al. Minimizing the Loss Produced by a Turbulent Separation Using Vortex Generator Jets[J]. AIAA Journal, 2012, 50(4): 778-787.
[18] Liesner K, Meyer R. Evaluation of Passive and Active Secondary Flow Control in a High Speed Compressor Cascade with Different Measurement Techniques [M]. Germany: New Results in Numerical and Experimental Fluid Mechanics VIII, Springer Berlin Heidelberg, 2013: 125-133.
[19] 张海灯, 吴云, 李应红, 等. 高速压气机叶栅旋涡结构及其流动损失研究[J]. 航空学报, 2014, 35(9): 2438-2450.
[20] 钟易成, 陈晓. 涡与涡以及涡与附面层之间相互作用的试验研究[J]. 航空动力学报, 1999, 14(1): 28-31.
[21] Compton D A, Johnston J P. Streamwise Vortex Production by Pitched and Skewed Jets in a Turbulent Boundary Layer [J]. AIAA Journal, 1992, 30(3): 640-647.　　　　　　　　　　　　　*　收稿日期:2016-01-29；修订日期:2016-03-23。基金项目:国家自然科学基金(51306042)。作者简介:王若玉,女,硕士生,研究领域为叶轮机械流动机理及控制。E-mail: wry392003711@gmail.com通讯作者:刘华坪,男,博士,讲师,研究领域为叶轮机械流动机理及控制。E-mail: hgdlhp@163.com(编辑:史亚红)