端壁合成射流对高负荷扩压叶栅损失特性的影响

推进技术 ›› 2017, Vol. 38 ›› Issue (9): 1975-1986.

端壁合成射流对高负荷扩压叶栅损失特性的影响

秦勇,王若玉,宋彦萍,刘华坪,陈浮

哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001,哈尔滨工业大学能源科学与工程学院，黑龙江哈尔滨 150001

发布日期:2021-08-15
作者简介:秦勇，男，博士生，研究领域为压气机流动机理及流动控制。
基金资助:
国家自然科学基金(51306042)。

Effects of Endwall Synthetic Jet on Loss Characteristics of a Highly Loaded Compressor Cascade

School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China,School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China,School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China,School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China and School of Energy Science and Engineering，Harbin Institute of Technology，Harbin 150001，China

Published:2021-08-15

摘要/Abstract

摘要： 利用端壁合成射流技术对高负荷扩压叶栅内的流动分离控制展开数值研究，探讨其改善损失的作用机理及影响因素。研究结果表明，端壁合成射流可以显著提升叶栅气动性能，使总压损失最大降低21.63%，静压升提高5.60%。射流形成的流向射流旋涡通过上洗/下洗作用促进了端壁附面层与主流高速流体间的动量交换，阻碍了通道涡向叶展中部的迁移、削弱其展向影响范围，并通过流向动量注入效应增大了激励缝下游流体的能量，从而推迟流动分离、降低叶栅损失。激励位置和射流角度是影响端壁合成射流作用效果的重要参数，当激励位于角区分离线上游附近且射流角度较小时，流动控制效果最佳。此外，提高射流动量也有助于增强其控制流动分离的能力。

关键词: 端壁合成射流；高负荷扩压叶栅；损失特性；气动性能；流动控制

Abstract: Numerical investigations for flow separation control were conducted on a highly loaded compressor cascade using endwall synthetic jet. The mechanism by which the actuation delays flow separation and reduces losses was explored and the effects of some dominant factors on the control effectiveness were analyzed in detail. Numerical results indicate that the endwall synthetic jet is able to improve the cascade aerodynamic performance remarkably，the total pressure loss could be reduced by 21.63% with a 5.60% static pressure rise increase. The streamwise jet vortex could enhance the momentum exchange between the sidewall boundary layer and the high momentum freestream fluid through upwash and downwash，which also impedes the migration of passage vortex towards the blade midspan and weakens its influence in spanwise direction. Moreover，the streamwise momentum addition by the jet could increase the energy level of the fluid downstream of the slot. The combined effects delay flow separation and reduce flow losses. Both actuation location and jet angle are important parameters for flow separation control. When the actuation is located in the near upstream of the corner separation line with a relatively small jet angle，the flow control system appears to be most efficient. Furthermore，the increase of jet momentum could also enhance its control effect on flow separation.

Key words: Endwall synthetic jet；Highly loaded compressor cascade；Loss characteristics；Aerodynamic performance；Flow control

秦勇,王若玉,宋彦萍,刘华坪,陈浮. 端壁合成射流对高负荷扩压叶栅损失特性的影响[J]. 推进技术, 2017, 38(9): 1975-1986.

QIN Yong,WANG Ruo-yu,SONG Yan-ping,LIU Hua-ping,CHEN Fu. Effects of Endwall Synthetic Jet on Loss Characteristics of a Highly Loaded Compressor Cascade[J]. Journal of Propulsion Technology, 2017, 38(9): 1975-1986.

参考文献

[1] Gbadebo S A, Cumpsty N A, Hynes T P. Three-Dimensional Separations in Axial Compressors [J]. Journal of Turbomachinery, 2005, 127(2): 331-339.
[2] Hergt A, Meyer R, Engel K. Effects of Vortex Generator Application on the Performance of a Compressor Cascade[J]. Journal of Turbomachinery, 2013, 135(2).
[3] Hergt A, Meyer R, Liesner K, et al. A New Approach for Compressor Endwall Contouring[R]. ASME 2011-GT-45858.
[4] Bryce J D, Cherrett M A, Lyes P A. Three-Dimensional Flow in a Highly Loaded Single-Stage Transonic Fan [J]. Journal of Turbomachinery, 1995, 117(1): 22-28.
[5] Lemke M, Gmelin C, Thiele F. Simulations of a Compressor Cascade with Steady Secondary Flow Suction [M]. Berlin: New Results in Numerical and Experimental Fluid Mechanics VIII.Springer, 2013.
[6] Liesner K, Meyer R, Gmelin C, et al. On the Performance of Boundary Layer Suction for Secondary Flow Control in a High Speed Compressor [R]. AIAA 2013-2749.
[7] 茅晓晨, 刘波, 曹志远, 等. 端壁射流对压气机叶栅角区分离控制的研究[J]. 推进技术, 2014, 35(12): 1615-1622. (MAO Xiao-chen, LIU Bo, CAO Zhi-yuan, et al. Research on Corner Separation Control for Compressor Cascade with End-Wall Jet Flow[J]. Journal of Propulsion Technology, 2014, 35(12): 1615-1622.)
[8] 刘华坪, 陈焕龙, 李德雄, 等. 射流旋涡发生器控制大折转角扩压叶栅二次流[J]. 航空动力学报, 2015, 30(4): 838-845.
[9] 冯岩岩, 宋彦萍, 刘华坪, 等. 不同攻角下端壁射流旋涡控制扩压叶栅分离流动研究[J]. 推进技术, 2015, 36(1): 54-60. (FENG Yan-yan, SONG Yan-ping, LIU Hua-ping, et al. Effects of End-Wall Vortex Generator Jet on Flow Separation Control in Compressor Cascade under Different Angles of Attack[J]. Journal of Propulsion Technology, 2015, 36(1): 54-60.)
[10] FENG Yan-yan, SONG Yan-ping, CHEN Fu, et al. Active Flow Separation Control Using Endwall Vortex Generator Jets in Highly Loaded Compressor Cascades[R]. ASME 2015-GT-42268.
[11] FENG Yan-yan, SONG Yan-ping, CHEN Fu, et al. Effect of Endwall Vortex Generator Jets on Flow Separation Control in a Linear Compressor Cascade[J]. Journal of Aerospace Engineering, 2015, 229(12): 2221-2230.
[12] Seifert A, Bachar T, Koss D, et al. Oscillatory Blowing: a Tool to Delay Boundary-Layer Separation[J]. AIAA Journal, 1993, 31: 2052-2060.
[13] Gmelin C, Zander V, Hecklau M, et al. Active Flow Control Concepts on a Highly Loaded Subsonic Compressor Cascade: Résumé of Experimental and Numerical Results [J]. Journal of Turbomachinery, 2012, 134(6).
[14] Braunscheidel E P, Culley D E, Zaman K B M Q. Application of Synthetic Jets to Reduce Stator Flow Separation in a Low Speed Axial Compressor[R]. AIAA 2008-602.
[15] 张攀峰, 王晋军, 冯立好. 零质量射流技术及其应用研究进展[J]. 中国科学(E 辑), 2008, 38(3): 321-349.
[16] ZHENG Xin-qian, ZHANG Yang-jun, XING Wei-dong, et al. Separation Control of Axial Compressor Cascade By Fluidic-Based Excitations[J]. Journal of Turbomachinery, 2011, 133(4).
[17] Matejka M, Safarik P, Popelka L, et al. Influence of Active Methods of Flow Control on Compressor Blade Cascade Flow [R]. ASME 2008-GT-51109.
[18] Traficante S, De Giorgi M G, Ficarella A. Flow Separation Control on a Compressor-Stator Cascade Using Plasma Actuators and Synthetic and Continuous Jets[J]. Journal of Aerospace Engineering, 2016, 29(3).
[19] De Giorgi M G, De Luca C G, Ficarella A, et al. Comparison between Synthetic Jets and Continuous Jets for Active Flow Control: Application on a NACA 0015 and a Compressor Stator Cascade[J]. Aerospace Science and Technology, 2015, 43: 256-280.
[20] Zander V, Hecklau M, Nitsche W, et al. Active Flow Control by Means of Synthetic Jets on a Highly Loaded Compressor Cascade[J]. Journal of Power and Energy, 2011, 225(7): 897-908.
[21] QIN Yong, WANG Ruo-yu, SONG Yan-ping, et al. Active Flow Separation Control on a Highly Loaded Compressor Stator Cascade with Synthetic Jets[R]. ASME 2016-GT-56830.
[22] Zander V, Dobriloff C, Lumpe M, et al. Wall Shear Stress Measurements on a Highly Loaded Compressor Cascade[J]. Journal of Turbomachinery, 2013, 135(1).
[23] Smith B L, Glezer A. The Formation and Evolution of Synthetic Jets[J]. Physics of Fluids, 1998, 10(9): 2281-2297.
[24] 钟易成, 陈晓. 涡与涡以及涡与附面层之间相互作用的试验研究[J]. 航空动力学报, 1999, 14(1): 27-30.(编辑:史亚红)　　　　　　　　　　　　　*　收稿日期:2016-05-30；修订日期:2016-07-21。基金项目:国家自然科学基金(51306042)。作者简介:秦勇,男,博士生,研究领域为压气机流动机理及流动控制。E-mail: qinyong1990@hit.edu.cn