叶顶间隙对非定常激振力及下游静子振动影响

推进技术 ›› 2018, Vol. 39 ›› Issue (1): 68-75.

叶顶间隙对非定常激振力及下游静子振动影响

文安健,罗晓天,马威,滕金芳

上海交通大学航空航天学院，上海 200240,上海交通大学航空航天学院，上海 200240,上海交通大学航空航天学院，上海 200240,上海交通大学航空航天学院，上海 200240

发布日期:2021-08-15
作者简介:文安健，男，硕士生，研究领域为发动机中压气机内部流场及叶片振动。

Effects of Tip-Clearance on Unsteady Exciting Force and Down-Stream Stator Vibration

School of Aeronautics and Astronautics，Shanghai Jiaotong University，Shanghai 200240，China,School of Aeronautics and Astronautics，Shanghai Jiaotong University，Shanghai 200240，China,School of Aeronautics and Astronautics，Shanghai Jiaotong University，Shanghai 200240，China and School of Aeronautics and Astronautics，Shanghai Jiaotong University，Shanghai 200240，China

Published:2021-08-15

摘要/Abstract

摘要： 压气机叶片叶顶间隙会产生泄漏流，对非定常流动及下游静子会产生一定影响。为研究不同叶顶间隙下非定常气流激振力以及静子叶片振动响应，对不同叶顶间隙下单级压气机的非定常流动进行计算。随后分析非定常结果的流动特性。再利用快速傅里叶变换对静子表面的非定常激振力进行频谱分析，并将按不同频率分阶的载荷加载到静叶上以求解振动响应。非定常结果表明随叶顶间隙增大，效率和压比与之呈线性递减关系，叶片表面时间平均的压力也随之降低。而激振力的频域结果表明，激振力主要频率与叶片通过频率接近，且一阶激振力效应最大。振动响应结果显示随叶顶间隙增加，振动幅值有所降低，但在20% ~ 40%叶高处有非线性现象，位移波谷有轻微下降。且前三阶响应结果接近静叶第3阶，第8阶和第17阶模态振型，频率相差为10%左右。

关键词: 叶顶间隙；非定常流动；气动激振力；振动；快速傅里叶变换

Abstract: Tip clearance of compressor blade will produce leakage flow， which can have a certain impact on unsteady flow and downstream stator. In order to study the unsteady flow excitation force and the vibration response of stator blades under different blade tip-clearances， the unsteady flow of single - stage compressor under different blade clearance is calculated. The flow characteristics of the unsteady results are then analyzed. After that， the unsteady exciting force of the stator surface is analyzed by fast Fourier transform， and the load is applied to the stator by frequency to solve the vibration response. Unsteady flow results indicate that as the tip clearance increase， the efficiency and the pressure ratio are linearly decreasing. In addition， the time average pressure on the surface also decreases. The frequency domain of the excitation force shows that the main frequency of the excitation force is close to the frequency of the blade passing frequency， and the first-order exciting force effect is the largest. And the results of vibration response show that the amplitude of the vibration decreases with the increase of the blade tip-clearance， but at 20% ~ 40% leaf height， there is a nonlinear phenomenon， the displacement has a slight decline. The first three order response results are close to the modal shapes of 3rd， 8th and 17th order， and the frequency difference is about 10%.

Key words: Tip-clearance；Unsteady flow；Aerodynamic exciting force；Vibration；Fast fourier transform

文安健,罗晓天,马威,滕金芳. 叶顶间隙对非定常激振力及下游静子振动影响[J]. 推进技术, 2018, 39(1): 68-75.

WEN An-jian,LUO Xiao-tian,MA Wei,TENG Jin-fang. Effects of Tip-Clearance on Unsteady Exciting Force and Down-Stream Stator Vibration[J]. Journal of Propulsion Technology, 2018, 39(1): 68-75.

参考文献

[1] Fruth F, Vogt D M, M?rtensson H, et al. Influence of the Blade Count Ratio on Aerodynamic Forcing Part I: Highly Loaded Transonic Compressor[R]. ASME GT 2010-22756.
[2] 王祥锋, 王松涛, 韩万金. 叶顶间隙变化对多级压气机性能影响的数值研究[J]. 科学技术与工程, 2009, 9(12): 3483-3486.
[3] Kielb Robert E, Barter John W, Thomas Jeffrey P, et al. Blade Excitation by Aerodynamic Instabilities: a Compressor Blade Study[R]. ASME GT 2003-38634.
[4] Thomassin J, Vo H D, Mureithi N W. Blade Tip Clearance Flow and Compressor NSV: The Jet Core Feedback Theory as the Coupling Mechanism[R]. ASME GT 2007-27286.
[5] 孙海鸥, 叶楠, 王纪达, 等. 叶顶间隙对轴流压气机性能及流场的影响[J]. 航空发动机, 2014, 40(3): 1-7.
[6] 杨静, 杨松. 汽轮机扭叶片叶顶间隙泄漏流动的数值分析[J]. 化工机械, 2016, 43(5): 655-659.
[7] 杜娟, 林峰, 张宏武, 等. 某跨音速轴流压气机转子叶顶泄漏流的非定常特征[J]. 工程热物理学报, 2009, 30(5): 749-752.
[8] 邓向阳, 张宏武, 朱俊强, 等. 压气机非定常叶顶间隙流的数值模拟研究[J]. 工程热物理学报, 2006, 27(2): 229-231.
[9] 吴艳辉, 李清鹏, 田江涛, 等. 轴流压气机转子叶尖二次涡的试验验证及形成机理[J]. 推进技术, 2012, 33(3): 363-370. (WU Yan-hui, LI Qing-peng, TIAN Jiang-tao, et al. Experimental Validation and Formation Mechanism Analysis of Tip Secondary Vortex in a Compressor Rotor[J]. Journal of Propulsion Technology, 2012, 33(3): 363-370.)
[10] 柴山, 张耀明, 曲庆文, 等. 汽轮机扭叶片级间隙气流激振力分析[J]. 中国电机工程学报, 2001, 21(5): 11-16.
[11] 王虎, 李琳. 尾流激振下叶片强迫响应数值计算方法[C]. 贵阳:中国航空学会发动机结构强度振动学术研讨会, 2008.
[12] 孙爱俊. 叶轮机叶片在流场中的强迫响应研究[C]. 宜昌:中国航空学会航空发动机可靠性学术交流会, 2005.
[13] 赵书军. 压气机三维非定常流计算与叶片强迫响应研究[D]. 西安:西北工业大学, 2003.
[14] Fu Z, Wang Y, Jiang X, et al. Tip Clearance Effects on Aero-Elastic Stability of Axial Compressor Blades[J]. Journal of Engineering for Gas Turbines & Power, 2014, 137(1).
[15] Moffatt S, He L. ?On Decoupled and Fully-Coupled Methods for Blade Forced Response Prediction[J]. Journal of Fluids & Structures, 2005, 20(2): 217-234.
[16] 薛亮, 韩万金, 黄家骅, 等. 单级压气机气动优化设计[J]. 推进技术, 2009, 30(4): 419-424. (XUE Liang, HAN Wan-jin, HUANG Jia-hua, et al. Aerodynamic Optimization Design of a Single Stage Compressor[J]. Journal of Propulsion Technology, 2009, 30(4):419-424.)
[17] 张成义, 张宏涛, 冯永志, 等. 叶顶间隙对某型压气机典型级气动性能的影响[J]. 汽轮机技术, 2013, 55(5): 359-360.
[18] Spalart P R, Allmaras S R. A One-Equation Turbulence Model for Aerodynamic Flows[J]. La Recherche Aérospatiale, 2003, 439(1): 5-21.
[19] 邓向阳. 压气机叶顶间隙流的数值模拟研究[D]. 北京:中国科学院工程热物理研究所, 2006.(编辑:张荣莉)　　　　　　　　　　　　　*　收稿日期:2017-04-06；修订日期:2017-06-05。作者简介:文安健,男,硕士生, 研究领域为发动机中压气机内部流场及叶片振动。E-mail: wenanjian@sjtu.edu.cn