考虑缺口和体积效应的轮盘等效体积概率寿命分析方法

推进技术 ›› 2018, Vol. 39 ›› Issue (12): 2820-2827.

考虑缺口和体积效应的轮盘等效体积概率寿命分析方法

苏运来,陆山,杨茂,刘小桃,张凭

西北工业大学动力与能源学院，陕西西安 710129,西北工业大学动力与能源学院，陕西西安 710129,西北工业大学动力与能源学院，陕西西安 710129,西北工业大学动力与能源学院，陕西西安 710129,西北工业大学动力与能源学院，陕西西安 710129

发布日期:2021-08-15
作者简介:苏运来，男，博士生，研究领域为航空发动机疲劳、寿命及可靠性分析。E-mail: suyunlai@163.com 通讯作者:陆山，男，博士，教授，研究领域为航空发动机结构强度、寿命可靠性分析及试验评估技术。

Equivalent Volume Analysis Method Accounting for Notch Effect and Volume Effect on Probabilistic Fatigue Life Estimation for Disk

School of Power and Energy，Northwestern Polytecnical University，Xi’an 710072，China,School of Power and Energy，Northwestern Polytecnical University，Xi’an 710072，China,School of Power and Energy，Northwestern Polytecnical University，Xi’an 710072，China,School of Power and Energy，Northwestern Polytecnical University，Xi’an 710072，China and School of Power and Energy，Northwestern Polytecnical University，Xi’an 710072，China

Published:2021-08-15

摘要/Abstract

摘要： 航空发动机轮盘的疲劳破坏多伴有缺口效应和体积效应。为了研究缺口效应和体积效应对疲劳寿命的影响，采用修正Walker模型考虑平均应力的影响，建立能统一描述各应力水平下疲劳寿命分布的三参数Weibull模型，在“等概率寿命、等损伤”的基本思想下，将轮盘大应力区的危险体积转换为具有相同损伤的等效体积，进而利用Weibull最弱环理论可获得具有缺口效应和体积效应的轮盘危险部位在任意失效概率下的疲劳寿命。对两种不同厚度(4mm和6mm)的涡轮盘螺栓孔模拟试件进行概率寿命预估，并与试验结果及应力体方法预估结果进行对比。结果显示，本方法对两种模拟试件的概率寿命预估结果最大误差在30%左右，在中位、高可靠度时的最大预估误差为-23.2%，预估精度高于应力体方法。

关键词: 轮盘；缺口效应；体积效应；韦布尔分布；等效体积

Abstract: The fatigue failure of aero-engine disks is always accompanied by notch effect and volume effect. To study the influence of notch effect and volume effect on fatigue life， the modified Walker model was used to consider mean stress effect， and the uniform three parameter Weibull distribution was established to account for the scatter of fatigue life under various stress levels. Based on the principle of ‘while the probabilistic fatigue lives are the same， the damage contained are equal’， the detrimental volume in the high stress region of disk was transferred to equivalent volume containing equal damage and accumulated. Furthermore， the weakest link theory was occupied to calculate the probabilistic fatigue life of components with notch effect and volume effect under any failure probability. The probabilistic fatigue lives of two simulated bolt-hole specimens of turbine disk with different thicknesses (4mm and 6mm) were investigated by the equivalent volumetric method proposed in this paper. Besides， the results from fatigue test data and the stress volumetric method were also provided for comparison. Through the comparison， it was shown that the prediction error of estimated probabilistic fatigue lives of the two specimens by the equivalent volumetric method were within 30% for all the cases examined， with the maximum prediction error being merely -23.2% for the medium and high reliability cases， providing better accuracy than the stress volumetric method.

Key words: Disk；Notch effect；Volume effect；Weibull distribution；Equivalent volume

苏运来,陆山,杨茂,刘小桃,张凭. 考虑缺口和体积效应的轮盘等效体积概率寿命分析方法[J]. 推进技术, 2018, 39(12): 2820-2827.

SU Yun-lai,LU Shan,YANG Mao,LIU Xiao-tao,ZHANG Ping. Equivalent Volume Analysis Method Accounting for Notch Effect and Volume Effect on Probabilistic Fatigue Life Estimation for Disk[J]. Journal of Propulsion Technology, 2018, 39(12): 2820-2827.

参考文献

[1] 李骏, 宋友辉, 刘汉斌, 等. 涡轮叶片-榫头-轮盘的蠕变与低循环疲劳寿命预测[J]. 推进技术, 2015, 36(11): 1699-1704. (LI Jun, SONG You-hui, LIU Han-bin, et al. Creep and Low Cycle Fatigue Life Prediction for Turbine Blade-Tenon-Disk Structure[J]. Journal of Propulsion Technology, 2015, 36(11): 1699-1704.)
[2] 牟园伟, 陆山. 轮盘低周疲劳概率寿命预估模型[J]. 推进技术, 2012, 33(2): 288-292. (MOU Yuan-wei, LU Shan. Low Cycle Fatigue Probabilistic Life Prediction Models for Fan Disk[J]. Journal of Propulsion Technology, 2012, 33(2): 288-292.)
[3] 唐俊星. 含夹杂粉末盘概率寿命三维仿真方法与应用[D]. 西安:西北工业大学, 2008.
[4] Peterson R E. Stress Concentration Factors[M]. New York: John Wiley & Sons, 1974.
[5] Neuber H. Theory of Notch Stresses[M]. Virginia: USAEC Office of Technical Information, 1961.
[6] Kuhn P, Hardran H F. An Engineering Method for Estimating Notch-Size Effect in Fatigue Tests of Steel[R]. NACA-TN-2805, 1952.
[7] Buch A. Evaluation of Size Effect in Fatigue Tests on Unnotched Specimens and Components[J]. Archiv Furdas Eisenhuttenwesen, 1972, 43(4): 885-900.
[8] Sheppard S D. Field Effects in Fatigue Crack Initiation: Long Life Fatigue Strength[J]. Journal of Mechanical Design, Transaction of the ASME, 1991, 113(2): 188-194.
[9] Bellett D, Taylor D, Marco S, et al. The Fatigue Behavior of Three-Dimensional Stress Concentrations[J]. International Journal of Fatigue, 2005, 27(3): 207-221.
[10] 辛朋朋, 胡绪腾, 宋迎东. 基于临界距离理论的TC4合金缺口试样低循环疲劳寿命预测[J]. 航空动力学报, 2012, 27(5): 1105-1112.
[11] Shirani M, Harkegard G. Fatigue Life Distribution and Size Effect in Ductile Cast Iron for Wind Turbine Components[J]. Engineering Failure Analysis, 2011, 18(1): 12-24.
[12] Daniel S, Marten O. An Investigation of the Prediction Accuracy for Volume Based HCF Models Using Scaled Geometries and Scaled Loading[J]. International Journal of Fatigue, 2016, 82(2): 317-324.
[13] Kristoffer K, Marten O. A Study of the Volume Effect and Scatter at the Fatigue Limit–Experimental and Computations for a New Specimen with Separated Notches[J]. International Journal of Fatigue, 2011, 33(3): 363-371.
[14] Kristoffer K, Marten O. A Investigation of a Fatigue Model with Two Competing Failure Mechanisms[J]. International Journal of Fatigue, 2014, 64(7): 131-139.
[15] Yao W X. Stress Field Intensity Approach for Prediction Fatigue Life[J]. International Journal of Fatigue, 1993, 15(3): 234-245.
[16] 陆山, 张鸿, 唐俊星, 等. 考虑尺寸效应的轮盘应力疲劳概率寿命分析方法[J]. 航空动力学报, 2011, 26(9): 2039-2043.
[17] 刘香, 王延荣, 田爱梅, 等. 考虑尺寸效应的缺口疲劳寿命预测方法[J]. 航空动力学报, 2017, 32(2): 429-437.
[18] Dowling N E, Calhoun C A, Arcari A. Mean Stress Effects in Stress-Life Fatigue and the Walker Equation[J]. Fatigue & Fracture of Engineering Materials & Structures, 2008, 32(3): 163-179.
[19] 苏运来, 陆山. 适用于任意应变比的应变寿命新模型[J]. 推进技术, 2018, 39(1): 169-175. (SU Yun-lai, LU Shan. A New Strain-Life Model Accounting for Effects of Various Strain Ratios[J]. Journal of Propulsion Technology, 2018, 39(1): 169-175.)
[20] 苏运来, 陆山, 杨茂, 等. 任意应力比下涡轮盘的塑性应变能寿命模型[J]. 航空动力学报, 2017, 32(4): 828-834.
[21] 谢里阳, 任俊刚, 吴宁祥, 等. 复杂结构部件概率疲劳寿命预测方法与模型[J]. 航空学报, 2015, 36(8): 2688-2695.
[22] 高振同, 熊俊江. 疲劳可靠性[M]. 北京:北京航空航天大学, 2000: 74-75.
[23] 奚蔚, 姚卫星. 缺口件疲劳寿命分布预测的有效应力法[J]. 固体力学学报, 2013, 34(2): 205-212.
[24] Weibull W. A Statistical Distribution Function of Wide Applicability[J]. ASME Journal of Applied Mechanics, 1951, 18(3): 293-297.
[25] 陆山, 王春光, 陈军. 任意最大应力梯度路径轮盘模拟试件设计方法[J]. 航空动力学报, 2010, 25(9): 2000-2005.　　　　　　　　　　　　　　收稿日期:2017-10-17；修订日期:2017-12-22。作者简介:苏运来,男,博士生,研究领域为航空发动机疲劳、寿命及可靠性分析。E-mail: suyunlai@163.com通讯作者:陆山,男,博士,教授,研究领域为航空发动机结构强度、寿命可靠性分析及试验评估技术。 (编辑:史亚红)