变几何低压涡轮气动性能研究

推进技术 ›› 2018, Vol. 39 ›› Issue (2): 269-276.

变几何低压涡轮气动性能研究

吴中野,方祥军

北京航空航天大学能源与动力工程学院，北京 100191,北京航空航天大学能源与动力工程学院，北京 100191

发布日期:2021-08-15
作者简介:吴中野，男，博士生，研究领域为涡轮气动设计与试验。

Research on Variable Geometry Low Pressure Turbine Aerodynamic Performance

School of Energy and Power Engineering，Beihang University，Beijing 100191，China and School of Energy and Power Engineering，Beihang University，Beijing 100191，China

Published:2021-08-15

摘要/Abstract

摘要： 为了探索变几何涡轮气动设计方案，导向器与动叶均采用厚前缘与后加载型叶片设计以及动叶进口负攻角设计。为了提高涡轮输出功，低压涡轮采用了大流道扩张角设计。应用数值方法对此设计涡轮进行了不同导向器开度以及有无导向器端壁径向间隙的涡轮气动性能与流场结构特性研究，并对大流道扩张角的导向器端壁径向间隙变化进行了理论分析。结果表明在设计点工况下，基本涡轮效率为0.903，相对折合流量为1.006，满足设计需求；大流道扩张角下，导向器端壁径向间隙对涡轮性能影响很大；在设计工况下，随着导向器开度的逐渐关小，涡轮主要气动参数反力度降低，通流流量下降，而效率变化相对较小，有利于调节发动机工作状态。在非设计工况下，涡轮效率随膨胀比变化亦相对较小。可见此设计变几何涡轮给发动机带来较大收益。

关键词: 变几何涡轮；厚前缘；后加载；负攻角；大扩张角；端壁径向间隙

Abstract: To explore the variable geometry turbine aerodynamic design plan， the thick leading edge and aft-loading blade is used both in the rotor and stator， and inlet negative incidence design is adopted by the rotor. In addition， the large expansion angle of meridional channel were used in low pressure turbine to improve the output power. Aerodynamic performance and flow filed of the turbine were analyzed by numerical method at the different stator opening with the stator radial gap or not， and the variation of endwall radial gap was analyzed at large expansion angle of meridional channel condition by the theoretical method. It is shown that at the design point the basic turbine efficiency is 0.903， and the relative corrected mass flow is 1.006 which both meet the design requirement. However， the endwall radial gap has a large influence on the turbine performance at large expansion angle of meridional channel condition. At the design condition， with the stator generally closed， the main aerodynamic parameter of reaction is decreased， the mass flow is reduced shapely， and the variation of efficiency is relatively small which will lead to the engine working condition being changed obviously. At off design condition， the efficiency variation also is small with the expansion ratio changed. It is visible that the variable geometry turbine will bring great advantages to the engine.

Key words: Variable geometry turbine；Thick leading edge；Aft-loading；Negative incidence；Large expansion angle；Endwall radial gap

吴中野,方祥军. 变几何低压涡轮气动性能研究[J]. 推进技术, 2018, 39(2): 269-276.

WU Zhong-ye,FANG Xiang-jun. Research on Variable Geometry Low Pressure Turbine Aerodynamic Performance[J]. Journal of Propulsion Technology, 2018, 39(2): 269-276.

参考文献

[1] 彭泽琰, 刘刚, 桂幸民, 等. 航空燃气轮机原理[M]. 北京:国防工业出版社, 2008.
[2] Silvern D H, Slivka W R. Analytical Investigation of Turbines with Adjustable Stator Blades and Effect of These Turbines on Jet-Engine Performance[R]. NACA, RME50E05.
[3] Messerlie R L, Cox D. Performance Investigation of Variable Turbine Geometry in Gas Turbine Engines[R].AIAA 67-417.
[4] Szanca E M, Behning F P, Schum H J. Effect of Variable Stator Area on Performance of a Single-Stage Turbine Suitable for Air Cooling[R]. NASA N68-29994.
[5] Latimer R J. Variable Flow Turbine[R]. AGARD, A040189P31, 1977
[6] Meyer C L, Smith I D, Bloomer H E. Performance of a Turbojet Engine with Adjustable First-Stage Turbine Stator and Variable-Area Exhaust Nozzle[R]. NACA, E52L04.
[7] 葛满初, 齐宗敏, 徐进, 等. 变几何变工质涡轮性能预测及变工况性能计算[J]. 推进技术, 1996, 17(1): 37-41. (GE Man-chu, QI Zong-min, XU Jin, et al. Characteristics Calculation at Design and Off-Design for Turbine with Variable Geometry and Medium[J]. Journal of Propulsion Technology, 1996, 17(1):37-41.)
[8] 胡松岩. 变几何涡轮及其设计特点[J]. 航空发动机, 1996, (3): 21-26.
[9] Yue G Q, Yin S Q, Zheng Q. Numerical Simulation of Flow Fields of Variable Geometry Turbine with Spherical Endwalls or Nonuniform Clearance[R]. ASME 2009-GT-59737
[10] 黄鹏, 乔渭阳, 魏佐君, 等. 球面端壁造型变几何涡轮流场和性能数值研究[J]. 机械与电子, 2014, (5): 32-36.
[11] 郑枫, 臧述升, 郁炜. 单级轴流式变几何涡轮的计算模型及结果分析[J]. 燃气轮机技术, 2003, 16(1): 39-42.
[12] 冯永明, 刘顺隆, 刘敏, 等. 船用燃气轮机变几何动力涡轮大攻角流动特性的三维数值模拟[J]. 热能动力工程, 2005, 20(5): 459-463.
[13] 刘顺隆, 冯永明, 刘敏, 等. 船用燃气轮机动力涡轮可调导叶级的流场结构[J]. 热能动力工程, 2005, 20(2): 120-124.
[14] 乔加飞. 对转涡轮气动优化设计及其热斑效应的研究[D]. 北京:中国科学院研究生院, 2012.
[15] 徐星仲, 朱斌. 一种“后部加载”型透平静叶的设计[J]. 工程热物理学报, 1997, 18(1): 48-52.
[16] 周逊, 韩万金. 后加载叶型叶栅的三维压力场及其对损失发展的影响[J]. 推进技术, 2003, 24(6): 537-542. (ZHOU Xun, HAN Wan-jin. Three-Dimensional Pressure Distribution of the Cascades with Aft-Loading Profile and the Influence of Loss Development[J]. Journal of Propulsion Technology, 2003, 24(6):537-542.)
[17] 安柏涛. 涡扇发动机涡轮低压导向器气动性能的实验和数值研究[D]. 哈尔滨:哈尔滨工业大学, 2002.
[18] Thomas P M, Warren J W, Harold J S. Performance of a Single-Stage Turbine as Affected by Variable Stator Area[R]. AIAA 69-525.
[19] Razinsky E H, Kuziak W R. Aerothermodynamic Performance of a Variable Nozzle Power Turbine Stage for an Automotive Gas Turbine[J]. Journal of Engineering for Gas Turbines & Power, 1977, 99(4): 587-592.
[20] 高杰, 郑群, 王付凯, 等. 一种具有正交型可调静叶片的大子午扩张变几何涡轮[P]. 中国专利:104100305A, 2014.　　　　　　　　　　　　　*　收稿日期:2016-11-16；修订日期:2016-12-15。作者简介:吴中野,男,博士生,研究领域为涡轮气动设计与试验。E-mail: wuzhongye@126.com(编辑:朱立影)