旋流燃烧室构型对固体燃料冲压发动机自持燃烧性能影响

推进技术 ›› 2018, Vol. 39 ›› Issue (6): 1312-1322.

旋流燃烧室构型对固体燃料冲压发动机自持燃烧性能影响

李唯暄¹,陈雄¹,周长省¹,杜红英²

南京理工大学机械工程学院，江苏南京 210094,南京理工大学机械工程学院，江苏南京 210094,南京理工大学机械工程学院，江苏南京 210094,晋西工业集团有限责任公司，山西太原 030000

发布日期:2021-08-15
作者简介:李唯暄，男，博士生，研究领域为固体燃料冲压发动机燃烧学。
基金资助:
总装备部预先研究项目(404040301)。

Effects of Combustion Chamber Configuration on Characteristic of Solid Fuel Ramjet Self-Sustaining Combustion in Swirl Flow

School of Mechanics Engineering，Nanjing University of Science and Technology，Nanjing 210094，China,School of Mechanics Engineering，Nanjing University of Science and Technology，Nanjing 210094，China,School of Mechanics Engineering，Nanjing University of Science and Technology，Nanjing 210094，China and Jinxi Industrial Refco Group Ltd，Taiyuan 030000，China

Published:2021-08-15

摘要/Abstract

摘要： 为研究燃烧室构型对引入旋流的固体燃料冲压发动机(SFRJ)燃烧特性的影响，通过改变药柱内径以改变相对台阶高度，利用高密度聚乙烯(HDPE)为固体燃料，对4种不同相对台阶高度的冲压发动机进行了旋流和直流连管实验，其中旋流工况的旋流数为0.6。利用Fortran语言编制CFD计算程序，对其中多个旋流工况进行了数值模拟，利用相关实验验证了计算程序的可靠性。仿真以及实验结果表明，在旋流工况下，相对台阶高度对火焰稳定以及燃烧特性有显著影响，当相对台阶高度为1.5时，旋流工况下发动机无法自持燃烧；在1.75相对台阶高度工况下，药柱表面热流密度与燃速均高于其他工况，且药柱平均燃速以及药柱表面热流密度会随相对台阶高度的升高而降低，最终趋于平缓；相对台阶高度的改变对特征速度与推力的作用不大，而在无旋工况下，特征速度和推力则随相对台阶高度的增加而增加。

关键词: 固体燃料冲压发动机；相对台阶高度；旋流数；火焰稳定；自持燃烧

Abstract: In order to study the effects of combustion chamber configuration on characteristic of solid fuel ramjet(SFRJ) self-sustaining combustion in swirl flow working condition， high density polyethylene(HDPE) were used as solid fuel， and relative step height were used as experimental variables by changing internal diameter of solid fuel， four groups of experiments were conducted in different relative step height， each group of experiments contains two sets of experiment in both swirl-flow and non-swirl-flow working condition， swirl number of swirl flow working condition were 0.6. A CFD code was developed to simulate the swirl flow conditions by using Fortran. And the reliability of this program is verified by experiments. The main results obtained from experiment results and simulation results show that the combustion characteristic and the flame stability are highly influenced by relative step height. For the engine of 1.5 relative step height in swirl-flow working condition， self-sustaining combustion were failed. For 1.75 relative step height in swirl-flow working condition， the heat flux along the surface and regression rate of HEPE are higher than other working condition， and the average regression rate and heat flux along the HDPE surface decrease with the increase of relative step height， but the decrease trend is flat gradually， the change of relative step height has no effect on characteristic velocities and thrust. On the non-swirl-flow working condition， the characteristic velocities and the thrust increased with the increasing of relative step height.

Key words: Solid fuel ramjet；Relative step height；Swirl number；Flame stability；Self-sustaining combustion

李唯暄,陈雄,周长省,杜红英. 旋流燃烧室构型对固体燃料冲压发动机自持燃烧性能影响[J]. 推进技术, 2018, 39(6): 1312-1322.

LI Wei-xuan¹,CHEN Xiong¹,ZHOU Chang-sheng¹,DU Hong-ying². Effects of Combustion Chamber Configuration on Characteristic of Solid Fuel Ramjet Self-Sustaining Combustion in Swirl Flow[J]. Journal of Propulsion Technology, 2018, 39(6): 1312-1322.

参考文献

[1] Pein R, Vinnemeier F. Swirl and Fuel Composition Effects on Boron Combustion in Solid-Fuelramjets[J]. Journal of Propulsion & Power, 2015, 8(3): 609-614.
[2] Hoegl A, Duesterhaus D. Measurement in a Solid Fuel Ramjet Combustion with Swirl[C]. Boston: 24th Joint Propulsion Conference, 1988.
[3] 魏韬, 武晓松. 基于动网格技术的固体燃料冲压发动机燃面瞬态退移速率研究[J]. 固体火箭技术, 2012, 35(4): 450-456.
[4] Al-Zurfi N, Turan A. A Numerical Simulation of the Effects of Swirling Flow on Jet Penetration in a Rotating Channel[J]. Flow, Turbulence and Combustion, 2015, 94(2): 415-438.
[5] 叶飞, 张堃元, 姜健, 等. 进气道旋流模拟及测量的实验研究[J]. 推进技术, 2009, 30(3): 297-301. (YE Fei, ZHANG Kun-yuan, JIANG Jian, et al. Experimental Investigation on Simulation and Measurement for Intake Swirl[J]. Journal of Propulsion Technology, 2009, 30(3): 297-301.)
[6] 马洋. 固体燃料冲压发动机涡流增强燃烧数值模拟与试验研究[D]. 长沙:国防科学技术大学, 2006.
[7] 刘巍. 固体燃料冲压发动机燃烧组织技术研究[D]. 长沙:国防科学技术大学, 2010.
[8] 刘巍, 杨涛. 固体燃料冲压发动机旋流燃烧特性数值研究[J]. 推进技术, 2011, 32(4): 504-508. (LIU Wei, YANG Tao. Numerical Study on the Swirl Flow Combustion Characteristics of Solid Fuel Ramjet[J]. Journal of Propulsion Technology, 2011, 32(4): 504-508.)
[9] 刘巍, 杨涛, 程兴华, 等. 旋流对轴对称喷管性能影响的数值研究[J]. 航空动力学报, 2010, 25(3):709-712.
[10] 刘巍, 李理, 杨涛. 旋转冲压增程弹进气道内流场旋流数计算[J]. 推进技术, 2009, 30(2): 149-153. (LIU Wei, LI Li, YANG Tao. Swirl Number Calculation in the Inlet of Spinning Ramjet Assisted Range Projectile[J]. Journal of Propulsion Technology, 2009, 30(2): 149-153.)
[11] 王洪远, 徐义华, 胡旭, 等. 空气旋转进气对含硼固体冲压发动机二次燃烧性能影响的研究[J]. 兵工学报, 2015, 36(4): 619-625.
[12] Musa O, Zhou C, Chen X, et al. Prediction of Swirling Cold Flow in a Solid-Fuel Ramjet Engine with a Modified Rotation/Curvature Correction SST Turbulence Model[J]. Applied Thermal Engineering, 2016, 105: 737-754.
[13] Musa O, Chen X, Zhou C, et al. Effect of Inlet Conditions on Swirling Turbulent Reacting Flows in a Solid Fuel Ramjet Engine[J]. Applied Thermal Engineering, 2016, 113: 186-207.
[14] 巩伦昆, 陈雄, 周长省, 等. 结构尺寸对固体燃料冲压发动机燃速影响的仿真研究[J]. 兵工学报, 2016, 37(5): 798-807.
[15] 巩伦昆, 陈雄, 周长省, 等. 来流条件对SFRJ燃速及自持燃烧性能的影响[J]. 航空学报, 2016, 37(5):1428-1439.
[16] Bianchi D, Nasuti F, Onofri M. Radius of Curvature Effects on Throat Thermochemical Erosion in Solid Rocket Motors[J]. Journal of Spacecraft and Rockets, 2014 , 52(2): 320-330.
[17] Gascoin N. Flash Pyrolysis of High Density PolyEthylene[C]. San Jose: AIAA/ASME/SAE/ASEE Joint Propulsion Conference, 2013-3833.
[18] 王兰. 超燃冲压发动机整机非结构网格并行数值模拟研究[D]. 绵阳:中国空气动力研究与发展中心, 2007.
[19] Evans J S, Schexnayder C J. Influence of Chemical Kinetics and Unmixedness on Burning in Supersonic Hydrogen Flames[J]. AIAA Journal, 1980, 18(2): 188-193.
[20] H F L. Experiments on Shock-Induced Combustion[J].Astronautica Acta, 1972, 17: 589-597.
[21] 杜新. 85%H2O₂-PE固液火箭发动机工作过程研究[D]. 西安:西北工业大学, 2003.　　　　　　　　　　　　　*　收稿日期:2017-05-06；修订日期:2017-06-16。基金项目:总装备部预先研究项目(404040301)。作者简介:李唯暄,男,博士生,研究领域为固体燃料冲压发动机燃烧学。E-mail: 382786894@qq.com(编辑:朱立影)