接受孔角度对预旋系统流动特性影响的数值研究 *

推进技术 ›› 2018, Vol. 39 ›› Issue (7): 1549-1555.

接受孔角度对预旋系统流动特性影响的数值研究 *

陈帆¹,王锁芳¹,张光宇¹,王海²

南京航空航天大学能源与动力学院，江苏省航空动力系统重点实验室，江苏南京 210016,南京航空航天大学能源与动力学院，江苏省航空动力系统重点实验室，江苏南京 210016,南京航空航天大学能源与动力学院，江苏省航空动力系统重点实验室，江苏南京 210016,中国航发沈阳发动机研究所，辽宁沈阳 110015

发布日期:2021-08-15
作者简介:陈帆，男，硕士生，研究领域为空气系统流动与冷却。 E-mail: cf861921232@163.com 通讯作者:王锁芳，男，博士，教授，研究领域为发动机流动与换热。

Numerical Studyon Effectsof Receiver Holes Angles on Flow Characteristicsof Pre-Swirl System

Nanjing University of Aeronautics and Astronautics，Jiangsu Province Key Laboratory of Aerospace Power System，Nanjing 210016，China,Nanjing University of Aeronautics and Astronautics，Jiangsu Province Key Laboratory of Aerospace Power System，Nanjing 210016，China,Nanjing University of Aeronautics and Astronautics，Jiangsu Province Key Laboratory of Aerospace Power System，Nanjing 210016，China and AECC Shenyang Engine Institute，Shenyang 110015，China

Published:2021-08-15

摘要/Abstract

摘要： 为研究接受孔对预旋系统流动特性的影响，基于简化的三维模型，对接受孔角度为 0°～ 60°的预旋系统进行了稳态数值模拟。结果表明，当气流周向速度高于接受孔旋转速度时，随着接受孔角度的增加，接受孔处的漩涡逐渐消失，有效流通面积增加。当气流周向速度低于接受孔旋转速度时，随着接受孔角度的增加，产生的漩涡逐渐变大，接受孔对气流的导向作用加强。随着接受孔角度的增加，接受孔附近气流的静温以及静压均减小，预旋系统无量纲质量流量和温降系数均增大，预旋系统总压损失系数呈微弱的上升趋势。接受孔角度从 0°增至 60°时，预旋系统温降系数增大了 22.7%，总压损

关键词: 预旋；流动特性；质量流量；温降；压力损失

Abstract: To investigate the effects of receiver holes on the flow characteristics of pre-swirl system，based on a 3D model，a steady state numerical simulation of the pre-swirl system with the receiver holes angles between0°and 60°was carried out. The results show that when the circumferential velocity of airflow is higher than that ofthe receiver holes，the vortexes near the receiver holes disappear gradually，and the effective flow areas increase with the angle of the receiver holes increasing. When the circumferential velocity of airflow is lower than that ofthe receiver holes，the vortexes gradually become larger，and the guiding effect of the receiver holes on the air.flow is strengthened with the receiver holes angle increasing. As the receiver holes angles increase，static temper. ature and static pressure of airflow near the receiver holes decrease，the dimensionless mass flow rate and the temperature drop coefficient of pre-swirl system increase，and the total pressure loss coefficient slightly rises. The temperature drop coefficient increases by 22.7%，and the total pressure loss coefficient increases by 1.31% as the receiver holes angles increase from 0°to 60°.

Key words: Pre-swirl；Flow characteristics；Mass flow；Temperature drop；Pressure loss

陈帆,王锁芳,张光宇,王海. 接受孔角度对预旋系统流动特性影响的数值研究 *[J]. 推进技术, 2018, 39(7): 1549-1555.

CHEN Fan¹,WANG Suo-fang¹,ZHANG Guang-yu¹,WANG Hai². Numerical Studyon Effectsof Receiver Holes Angles on Flow Characteristicsof Pre-Swirl System[J]. Journal of Propulsion Technology, 2018, 39(7): 1549-1555.

参考文献

[1] Meierhofer B,Franklin C J.An Investigation of a Pre.swirled Cooling Airflow to a Turbine Disc by Measuringthe Air Temperature in the Rotating Channels[R].ASME GT 1981-132.
[2] Javiya U,Chew J,Hills N,et al.A Comparative Studyof Cascade Vanes and Drilled Nozzle Designs for Pre-Swirl[R].ASME GT 2011-46006.
[3] Dittmann M,Geis T,Schramm V,et al.Discharge Co.efficients of a Pre-Swirl System in Secondary Air Sys.tems[R].ASME 2001-GT-0122.
[4] Bricaud C,Geis T,Dullenkopf K,et al.Measurement and Analysis of Aerodynamic and Thermodynamic Loss.es in Pre-Swirl System Arrangements[R].ASME GT 2007-2791.
[5] Yan Y,Gord M F,Lock G D,et al.Fluid Dynamics of a Pre -Swirl Rotor-Stator System[J].Journal of Tur.bomachinery,2003,125(4): 805-813.
[6] 刘高文,李碧云,蒋兆午,等 .预旋角度对预旋孔流动特性的影响[ J].推进技术, 2012,33(5): 740-746.(LIU Gao-wen,LI Bi-yun,JIANG Zhao-wu,et al.Ef.fects of Pre-Swirl Angle on Flow Character istics of Pre-Swirl Nozzle[J].Journal of Propulsion Technology, 2012,33(5): 740-746.)
[7] 刘高文,张林,李碧云,等 .扩口孔型预旋喷嘴流动与温降特性[ J].推进技术, 2013,34(3): 390-396.(LIU Gao-wen,ZHANG Lin,LI Bi-yun,et al.Inves.tigation on Flow Characteristics and Temperature Drop of an Aerodynamic -Hole Typed Pre -Swirl Nozzle[J].Journal of Propulsion Technology,2013,34(3): 390-396.)
[8] 朱晓华,刘高文,刘松龄,等 .带盖板的预旋系统温降和压力损失数值研究[ J],航空动力学报, 2010,(11): 2498-2506.
[9] 张建超 .冷气预旋结构的温降与流阻特性研究[ D].南京:南京航空航天大学, 2014.
[10] Idris A,Pullen K R.Correlations for the Discharge Co.efficient of Rotating Orifices Based on the Incidence An.gle[J].Proceedings of the Institution of Mechanical En.gineers Part A Journal of Power & Energy,2005,219(219): 333-352.
[11] Jarzombek K,Dohmen H J,Benra F K,et al.Flow Analysis in Gas Turbine Pre-Swirl Cooling Air Systems:Variation of Geometric Parameters[J].American Society of Mechanical Engineers,2006: 1403-1411.
[12] Owen J M,Rogers R H.Flow and Heat Transfer in Ro.tating -Disk Systems,Volume 1-Rotor Stator Systems[J].Research Studies Press,1989,90: 81-103.
[13] Karabay H,Wilson M,Owen J M.Prediction of Effect of Swirl on Flow and Heat Transfer in a Rotating Cavity[J].International Journal of Heat and Fluid Flow, 2001,22(2): 143-155.
[14] 蔡旭,徐国强,罗翔,等 .直接供气预旋转静系流动特性的实验[ J].航空动力学报, 2012,27(10): 2222-2228.
[15] 张建超,王锁芳 .带导流片的径向预旋系统流动结构数值研究[ J].重庆理工大学学报自然科学版, 2014, 28(1): 43-48.
[16] 朱晓华 .带盖板的预旋系统数值研究[ D].西安:西北工业大学, 2010.
[17] 祝昭 .转/静交界面处理方法研究及涡轮结构与气动分析[ D].南京:南京航空航天大学, 2008.* 收稿日期: 2017-06-23；修订日期: 2017-07-25。作者简介:陈帆,男,硕士生,研究领域为空气系统流动与冷却。 E-mail: cf861921232@163.com通讯作者:王锁芳,男,博士,教授,研究领域为发动机流动与换热。 E-mail: sfwang@nuaa.edu.cn (编辑:史亚红)