径向进气系统设计探讨及实验研究

推进技术 ›› 2018, Vol. 39 ›› Issue (9): 1948-1954.

径向进气系统设计探讨及实验研究

邵冬^1,2,孙志刚¹,吴世勋¹,田拥胜¹,谭春青¹

中国科学院工程热物理研究所，轻型动力实验室，北京 100190; 中国科学院大学，北京 100049,中国科学院工程热物理研究所，轻型动力实验室，北京 100190,中国科学院工程热物理研究所，轻型动力实验室，北京 100190,中国科学院工程热物理研究所，轻型动力实验室，北京 100190,中国科学院工程热物理研究所，轻型动力实验室，北京 100190

发布日期:2021-08-15
基金资助:
中国科学院科技创新基金(CXJJ-16S034)。

Design Exploration and Experimental Investigation for a Radial Air Intake System

Key Laboratory of Light-Duty Gas-Turbine，Institute of Engineering Thermophysics，Chinese Academy of Sciences， Beijing 100190，China;University of Chinese Academy of Sciences，Beijing 100049，China,Key Laboratory of Light-Duty Gas-Turbine，Institute of Engineering Thermophysics，Chinese Academy of Sciences， Beijing 100190，China,Key Laboratory of Light-Duty Gas-Turbine，Institute of Engineering Thermophysics，Chinese Academy of Sciences， Beijing 100190，China,Key Laboratory of Light-Duty Gas-Turbine，Institute of Engineering Thermophysics，Chinese Academy of Sciences， Beijing 100190，China and Key Laboratory of Light-Duty Gas-Turbine，Institute of Engineering Thermophysics，Chinese Academy of Sciences， Beijing 100190，China

Published:2021-08-15

摘要/Abstract

摘要： 对于双轴压气机实验平台径向进气系统，为研究蜂窝器改善系统供气品质所发挥的作用，应用数值模拟对蜂窝器在进气道的布置位置进行研究，并应用五孔探针实验测量了含有蜂窝器的进气系统过渡段处的气动参数。模拟结果显示蜂窝器布置在弯头的前部及中部均能有效改善流动。实验测量结果显示气流偏航角小于2°，总压、静压及马赫数周向分布均匀，总压恢复系数大于98.3%。实验结果与模拟结果吻合较好，验证了数值研究方法的可信度和可靠性，同时也证明该进气系统的先进性。

关键词: 进气系统；双轴压气机；气流均匀度；蜂窝器

Abstract: As for a radial air intake system of dual compressor test rig， in order to investigate improvements that honeycomb makes in supply flow qualities of intake system ， the location of honeycombs in the intake pipe was studied with numerical simulation method and the air parameters at the transition of the intake system containing the honeycombs were measured by five-hole probes. The numerical results showed that the front and middle honeycomb configurations in the elbow of the intake pipe have better performances. Experimental results showed that the yaw angle is less than 2°， the circumferential distributions of the total pressure， static pressure and Mach number are quite uniform， and the total pressure recovery coefficient is greater than 98.3%. The experiment results agreed the numerical simulations well， and the studies proved the credibility and reliability of the numerical simulation method and also the advantage of the air intake system design.

Key words: Intake system；Dual compressor；Flow uniformity；Honeycomb

邵冬,孙志刚,吴世勋,田拥胜,谭春青. 径向进气系统设计探讨及实验研究[J]. 推进技术, 2018, 39(9): 1948-1954.

SHAO Dong^1,2,SUN Zhi-gang¹,WU Shi-xun¹,TIAN Yong-sheng¹,TAN Chun-qing¹. Design Exploration and Experimental Investigation for a Radial Air Intake System[J]. Journal of Propulsion Technology, 2018, 39(9): 1948-1954.

参考文献

[1] Williams D D. Review of Current Knowledge on Engine Response to Distorted Inlet Flow Conditions[R]. AGARD CP-400, 1986.
[2] 管前列. 国外双轴压气机实验技术[J]. 推进技术, 1996, 17(2): 88-92. (GUAN Qian-lie. Test Technique of Dual-Spool Compressor System Abroad[J]. Journal of Propulsion Technology, 1996, 17(2): 88-92.)
[3] Flathers M, Bache G E, Rainsberger R. An Experimental and Computational Investigation of Flow in a Radial Inlet of an Industrial Pipeline Centrifugal Compressor[R]. ASME 94-GT-134.
[4] Simone P, Vittorio M. Analysis and Design Outlines of Centrifugal Compressor Inlet Volutes[R]. ASME 2000-GT-0464.
[5] Kim Y, Koch J. Design and Numerical Investigation of Advanced Radial Inlet for a Centrifugal Compressor Stage[R]. IMECE 2004-60538
[6] Koch J M, Chow P N, Hutchinson B R, et al. Experimental and Computational Study of a Radial Compressor Inlet[R]. ASME 95-GT-082.
[7] Engeda A, Kim Y, Aungier R, et al. The Inlet Flow Structure of a Centrifugal Compressor Stage and Its Influence on the Compressor Performance[J]. Journal of Fluids Engineering, 2003, 125(5): 779-785.
[8] 王锐, 祁大同, 王学军, 等. 离心压缩机径向吸气室内部流动的数值研究[J]. 流体机械, 2008, 36(6):19-24.
[9] Han F, Qi D, Tan J, et al. Experimental and Numerical Investigation of the Flow Field in the Radial Inlet of a Centrifugal Compressor[R]. ASME 2012-GT-69353.
[10] 陈宗华, 谷传纲, 舒信伟. 基于 CFD 技术的离心压缩机径向进气室结构形状优化设计[J]. 机械工程学报, 2010, 46(14): 124-129.
[11] 刘子娟. 主动控制湍流模拟风洞系统设计[D]. 上海:上海交通大学, 2013.
[12] 蒋啸, 张启璆. 风量测量用整流器的实验研究[J]. 中国电机工程学报, 2006, 26(14): 104-108.
[13] 邵冬, 孙志刚, 吴世勋, 等. 一种新颖径向进气系统的研究[J]. 推进技术, 2017, 38(12). (SHAO Dong, SUN Zhi-gang, WU Shi-xun, et al. Investigation on a Novel Radial Air Intake System[J]. Journal of Propulsion Technology, 2017, 38(12).)
[14] Kim J, Yadav M, Kim S. Characteristics of Secondary Flow Induced by 90-Degree Elbow in Turbulent Pipe Flow[J]. Engineering Applications of Computational Fluid Mechanics, 2014, 8(2): 229-239.
[15] Dean W R, Hurst J M. Note on the Motion of Fluid in a Curved Pipe[J]. Mathematika, 1959, 6(1): 77-85.(编辑:张荣莉)　　　　　　　　　　　　　*　收稿日期:2017-07-05；修订日期:2017-10-12。基金项目:中国科学院科技创新基金(CXJJ-16S034)。通讯作者:邵冬,男,博士生,研究领域为叶轮机械气动热力学。E-mail: shaodong@iet.cn