热线风速仪非标定工况下测试修正方法研究

推进技术 ›› 2018, Vol. 39 ›› Issue (9): 2094-2101.

热线风速仪非标定工况下测试修正方法研究

张云伟,全永凯

北京航空航天大学能源与动力工程学院航空发动机气动热力国家级重点实验室，北京 100191,北京航空航天大学能源与动力工程学院航空发动机气动热力国家级重点实验室，北京 100191

发布日期:2021-08-15
作者简介:张云伟，男，硕士生，研究领域为航空推进理论与工程。E-mail: 547904068@qq.com 通讯作者:全永凯，男，博士，副教授，研究领域为航空测试技术。

Research on Reduction Method for Measurement by Hot Wire Anemometer on Non-Calibrated Conditions

National Key Laboratory of Science and Technology on Aero-Engine Aero-Thermodynamics，School of Energy and Power Engineering，Beihang University，Beijing 100191，China and National Key Laboratory of Science and Technology on Aero-Engine Aero-Thermodynamics，School of Energy and Power Engineering，Beihang University，Beijing 100191，China

Published:2021-08-15

摘要/Abstract

摘要： 为提高热线风速仪在非标定温度、压力流场下的测速精度以扩大其应用范围，对热线风速仪的换热理论模型进行了深入分析以及详细的理论推导。以热线的四种换热形式为基础，从理论上对热线探针热丝的换热进行了计算分析，在综合考虑强迫对流、自然对流、辐射换热、支架导热后，发现不同来流速度下的强迫对流占比是不同的。而在同一来流速度下，强迫对流占比几乎不随温度变化而变化，但随压力变化较大。以此为基础，综合考虑了温度、压力引起的物性参数变化对热丝换热的影响，以及由此导致的热丝电压值的变化，最终给出了一种新的适用于非标准工况的热线风速仪测试修正方法及修正公式。与公开文献数据进行了比对，平均误差0.68%，最大误差2.2%。证明该修正方法具有较高精度。

关键词: 热线风速仪；温度；压力；修正方法；速度测量

Abstract: Aiming at expanding the application range by improving the accuracy of measurement using hot wire anemometer not calibrated over a range of temperatures and pressures， the heat transfer model of hot wire anemometer was analyzed theoretically and the derivations were carried out. Based on the four types of heat transfer， the heat transfer was calculated and analyzed. Considering forced convection， natural convection， heat radiation and heat conduction， it is found that the forced convection proportion is different under different flow velocities. In the same flow velocity， the forced convection proportion almost does not change with the temperatures， but changes a lot with the pressures. Based on this， a new reduction method and formula were put forward， which can be applied on non-calibrated conditions， considering the changes of the physical property parameters caused by temperature and pressure， as well as the voltage of hot wire. Public literature data were compared， the average error was 0.68%， the maximum error was 2.2%. It proved that the reduction method has high accuracy.

Key words: Hot wire anemometer；Temperature；Pressure；Reduction method；Velocity measurement

张云伟,全永凯. 热线风速仪非标定工况下测试修正方法研究[J]. 推进技术, 2018, 39(9): 2094-2101.

ZHANG Yun-wei,QUAN Yong-kai. Research on Reduction Method for Measurement by Hot Wire Anemometer on Non-Calibrated Conditions[J]. Journal of Propulsion Technology, 2018, 39(9): 2094-2101.

参考文献

[1] 盛森芝, 沈熊, 舒炜. 流速测量技术[M]. 北京:北京大学出版社, 1987.
[2] 李敏毅, 甘妙昌, 马思龙. 热线风速仪测量原理简介[C]. 杭州:压力计量服务和测试技术研讨会, 2003.
[3] Bearman P W. Correction for the Effect of Ambient Temperature Drift on Hot-Wire Measurements in Compressible Flow[J]. DISA Information, 1971, (11): 25-30.
[4] Bremhorst K. Effect of Fluid Temperature on Hot-Wire Anemometers and an Improve Method of Temperature Compensation and Linearisation Without Use of Small Signal Sensitivities[J]. Journal of Physics E: Scientific Instruments, 1985, 18(1): 44-49.
[5] Lekakis I C, Adrian R J, Jones B G. Measurement of Velocity Vectors with Orthogonal and Non-Orthogonal Triple-Sensor Probes[J]. Experiments in Fluids, 1989, 7(4): 228-240.
[6] John J, Schobeiri T. A Simple and Accurate Method of Calibrating X-Probes[J]. Journal of Fluids Engineering, 1993, 115(1): 148-152.
[7] Lenoms G, Dracos T. A New Calibration and Data Reduction Method for Turbulence Measurement by Multihotwire Probes[J]. Experiments in Fluids, 1995, 18(5): 319-328.
[8] Kostka M, Vasanta Ram V. On the Effects of Fluid Temperature on Hot Wire Characteristics [J]. Experiments in Fluids, 1992, 13(23): 155-162.
[9] Abdel-Rahman A, Tropea C?, Slawson P. On Temperature Compensation in Hot-Wire Anemometry[J]. Journal of Physics E: Scientific Instruments, 2000, 20(3): 315-319.
[10] 邓康耀. 可变几何涡轮增压和排气管系二维不稳定流场研究[D]. 上海:上海交通大学, 1991.
[11] 梁雄耀. 热线风速仪输出信号的温度和压力修正[J]. 重庆交通学院学报, 1993, 12(1): 80-88.
[12] 张万路. 热线风速仪在线测量的修正模型[J]. 计量技术, 2004, (5): 27-28.
[13] 马超, 黄名海, 葛冰, 等. 高温风洞中空冷涡轮叶片冷却特性的实验研究[J]. 推进技术, 2016, 37(3):496-503. (MA Chao, HUANG Ming-hai, GE Bing, et al. Experimental Investigation of Cooling Performance of Air-Cooled Turbine Blade in a High-Temperature Wind Tunnel[J]. Journal of Propulsion Technology, 2016, 37(3): 496-503.)
[14] 朱惠人, 向安定, 许都纯, 等. 涡轮叶片表面气膜冷却效率的实验研究[J]. 推进技术, 2003, 24(6): 528-531. (ZHU Hui-ren, XIANG An-ding, XU Du-chun, et al. An Experimental Investigation of Film Cooling Effectiveness on the Surface of Turbine Blade[J]. Journal of Propulsion Technology, 2003, 24(6): 528-531.)
[15] Chaluvadi V S P, Kalfas A I, Hodson H P. Vortex Transport and Blade Interactions in High Pressure Turbines[J]. Journal of Turbomachinery, 2004, 126(3):395-405.
[16] 高丽敏, 席光, 王尚锦, 等. 用热线风速仪测量叶轮后叶片扩压器流场[J]. 工程热物理学报, 2005, 26(4): 599-601.
[17] 魏宽, 陶智, 邓宏武, 等. 旋转状态下方形通道内部流场特性热线实验[J]. 航空动力学报, 2016, 31(11): 2635-2640.
[18] Quix H, Quest J, Brzek C. Hot-Wire Measurements in Cryogenic Environment[C]. Orlando: 49th US AIAA Aerospace Science Meeting, 2011.
[19] Struk P M, Rigby D L, Venkatara K. A Thermal Analysis of a Hot-Wire Probe for Icing Applications[C]. US: 6th AIAA Atmospheric and Space Environments Conference, 2014.
[20] 王鑫, 杨颖, 马云驰, 等. 应用热线风速仪对熔喷流场的温度速度同步测量方法[J]. 实验流体力学, 2016, 30(1): 91-96.
[21] 王仑, 周远, 侯宇葵. 热线风速仪低温测速的初步研究[J]. 真空与低温, 2001, 7(2): 89-91.
[22] 杜钰锋, 林俊, 马护生, 等. 可压缩流体恒温热线风速仪校准方法[J]. 航空动力学报, 2017, 38(6).
[23] 论立勇, 陈厚磊, 蔡京辉. 高压交变流动下热线风速仪标定方法研究[J]. 实验流体力学, 2010, 24(3): 87-91.
[24] 姚惠元, 刘国政, 孙楠, 等. 恒温热线风速仪的一种新型校准方法[J]. 现代电子技术, 2013, 36(23): 110-112.
[25] 陈曦, 沙奕卓, 吕文华. 热线流速仪在风洞流场测试中的应用[J]. 仪器仪表学报, 2011, 32(12): 356-360.
[26] 李鹏, 崔骊水, 李金海, 等. 热线风速仪微风速下的校准实验研究[J]. 计量技术, 2016, (9): 3-7.
[27] 韦青燕, 张天宏. 高超声速热线热膜风速仪研究综述及分析[J]. 测试技术学报, 2012, 26(2): 142-149.
[28] Hilpert R. Heat Transfer from Cylinders[J]. Forsch Geb Ingenieurwes, 1933, (4): 215-224.
[29] 李友荣. 高等传热学[M]. 北京:科学出版社, 2013.
[30] Kays William, Crawford Michael, Weigand Bernhar著. 对流传热与传质[M]. 赵镇南译. 北京:高等教育出版社, 2007.
[31] 侯亚丽, 汪建文, 刘志刚. 微细长竖圆柱外侧的自然对流换热[J]. 制冷学报, 2013, 34(2): 60-65.
[32] 田立楠. 纯气体混合气体及液体导热系数的计算[J]. 氮肥设计, 1996, 34(4): 19-22.　　　　　　　　　　　　　*　收稿日期:2017-11-08；修订日期:2017-12-04。作者简介:张云伟,男,硕士生,研究领域为航空推进理论与工程。E-mail: 547904068@qq.com通讯作者:全永凯,男,博士,副教授,研究领域为航空测试技术。 E-mail: quanyongkai@126.com (编辑:史亚红)