静环振动对涡轮泵端面密封失效的影响

推进技术 ›› 2019, Vol. 40 ›› Issue (5): 1129-1135.

静环振动对涡轮泵端面密封失效的影响

陈鹏飞,尚冬琴,周立新

西安航天动力研究所液体火箭发动机技术重点实验室，陕西西安 710100,西安航天动力研究所液体火箭发动机技术重点实验室，陕西西安 710100,西安航天动力研究所液体火箭发动机技术重点实验室，陕西西安 710100

发布日期:2021-08-15

Effects of Stationary Seal Ring Vibration on End-Face Sealing Failure in Turbo Pump

Science and Technology on Liquid Rocket Engine Laboratory，Xi’an Aerospace Propulsion Institute， Xi’an 710100，China,Science and Technology on Liquid Rocket Engine Laboratory，Xi’an Aerospace Propulsion Institute， Xi’an 710100，China and Science and Technology on Liquid Rocket Engine Laboratory，Xi’an Aerospace Propulsion Institute， Xi’an 710100，China

Published:2021-08-15

摘要/Abstract

摘要： 为了深入认识涡轮泵端面密封的失效机理，采用动网格方法和可压缩液体模型模拟了静环简谐振动对密封腔内流体的激励作用，获得了静环脱开的力学条件，并研究了静环振动对密封失效的影响规律和改进措施。计算结果表明，静环简谐振动将激励密封腔内流体产生压力脉动，并在静环两侧形成较大的压力差；静环承受的净作用力周期性波动，在位移处于π/2相位时达到最大值；随着静环振动频率和幅值增大，最大净作用力也不断增大，最终达到静环脱开泄漏的条件。在简谐振动作用下，净作用力峰值受振动频率影响较大；在脉冲冲击作用下，净作用力峰值与冲击过程有关，而与脉冲的出现频率关系不大。通过连通静环两侧的流体，可以减弱静环振动产生的激励作用，大幅降低净作用力的脉动峰值，从而提高端面密封的可靠性。

关键词: 端面密封；数值模拟；压力脉动；振动；涡轮泵

Abstract: In order to understand the failure mechanism of turbo pump end-face seal，the dynamic grid method and the compressible liquid model were used to simulate the excitation effect of stationary seal ring vibration on the fluid in the seal cavity，and the mechanical conditions of the seal ring undoes are obtained. The influence rules and improvement measures of the stationary seal ring vibration on the sealing failure were also studied. The results show that the ring harmonic vibration will motivate fluid pressure pulsations in the seal cavity，and lead a larger pressure difference on both sides of the ring. Net force in the stationary seal ring changes periodically which will reach the maximum value on the displacement of π/2 phase. With the vibration frequency and amplitude increasing，the maximum net force also increased，ultimately the stationary seal ring will undo and leak. Under the effect of simple harmonic vibration，the peak value of net force is greatly influenced by the vibration frequency. Under the impulse shock process，the net force is related to the impact process，but is not much related to the frequency of the pulse. By connecting the fluid on both sides of the ring，the exciting effect generated by the vibration is weakened，and the peak value of the net force is greatly reduced，so the reliability of the end-face seal is improved.

Key words: End-face seal；Numerical simulation；Pressure fluctuation；Vibration；Turbo pump

陈鹏飞,尚冬琴,周立新. 静环振动对涡轮泵端面密封失效的影响[J]. 推进技术, 2019, 40(5): 1129-1135.

CHEN Peng-fei,SHANG Dong-qin,ZHOU Li-xin. Effects of Stationary Seal Ring Vibration on End-Face Sealing Failure in Turbo Pump[J]. Journal of Propulsion Technology, 2019, 40(5): 1129-1135.

参考文献

[1] Razzaque M M, Faisal M T R. Effects of the Shape of Surface Micropores on the Performance of a Face Seal[J]. Journal of Mechanical Engineering, 2007, 38(6): 25-31.
[2] Zhao Zhong, Peng Xudong, Sheng Songen, et al. Numerical Analysis of Laser Textured Mechanical Seals with a Porous Sector Face[J]. Journal of the Chemical Industry and Engineering Society of China, 2009, 60(4): 965-971.
[3] Feldman Y, Kligerman Y, Etsion I. Stiffness and Efficiency Optimization of a Hydrostatic Laser Surface Textured Gas Seal[J]. Journal of Tribology, 2007, 129(2): 407-410.
[4] Razzaque M M, Faisal M T R. Performance of Mechanical Face Seals with Surface Micropores[J]. Journal of Mechanical Engineering, 2007, 37(6): 77-80.
[5] Wang X, Adachi K, Otsuka K, et al. Optimization of the Surface Texture for Silicon Carbide Sliding in Water [J]. Applied Surface Science, 2006, 253(3): 1282-1286.
[6] 张绪猛, 朱汉华, 高岚, 等. 机械端面密封的动力学特性分析[J]. 船舶工程, 2009, 31(3): 18-21.
[7] 李茂元, 吴玉国, 吴胜, 等. 复合表面微凹坑对机械端面密封动压性能的影响[J]. 工程设计学报, 2014, 21(6): 540-544.
[8] 吴勋, 刘纪涛, 肖飞, 等. 涡轮泵端面密封贮存仿真及可靠性分析[J]. 空军工程大学学报(自然科学版), 2009, 10(4): 15-19.
[9] 吴勋, 谢红雨, 陈广南, 等. 液体发动机涡轮泵端面密封长期贮存变形研究[J]. 宇航材料工艺, 2008, 38(5): 29-32.
[10] 白东安, 段增斌, 张翠儒. 涡轮泵端面密封性能与漏气量影响研究[J]. 火箭推进, 2010, 36(1): 38-42.
[11] 杜功焕, 朱哲民, 龚秀芬, 等. 声学基础[M]. 南京:南京大学出版社, 2001: 168-180.
[12] Muntz E P, Orme M, Farnham T, et al. Liquid Droplet Generation[R]. NASA-CR-182246, 1989.
[13] Orme M, Muntz E P. New Technique for Producing Highly Uniform Droplet Streams over an Extended Range of Disturbance Wavenumbers[J]. Review of Scientific Instruments, 1987: 58(2): 279-284.
[14] Chen Y S, Huang Y L, Kuo C H. Investigation of Design Parameters for Droplet Generators Driven by Piezoelectric Actuators[J]. International Journal of Mechanical Sciences, 2007, 49(6): 733-740.
[15] 周诗贵, 习俊通. 压电驱动膜片式微滴喷射仿真与尺度一致性试验研究[J]. 机械工程学报, 2013, 49(8): 178-185.
[16] 陈鹏飞, 徐云飞, 孙策, 等. 多射流喷射器的压电激励特性[J]. 航空动力学报, 2017, 32(8): 1815-1821.
[17] 张鸣远, 景思睿, 李国君. 高等工程流体力学[M]. 西安:西安交通大学出版社, 2006.
[18] Poling B E, Prausnitz J M, O’Connell J P. The Properties of Gases and Liquids: Fifth Edition[M]. New York: The McGraw-Hill Companies, 2001.　　　　　　　　　　　　　　收稿日期:2018-03-20；修订日期:2018-06-22。通讯作者:陈鹏飞,硕士,高级工程师,研究领域为液体火箭发动机技术。E-mail: cpf0525@163.com(编辑:史亚红)