ADN基推力器热回浸对毛细管微尺度流动特性影响的数值模拟研究

doi:10.13675/j.cnki. tjjs. 190017

推进技术 ›› 2020, Vol. 41 ›› Issue (1): 101-108.DOI: 10.13675/j.cnki. tjjs. 190017

ADN基推力器热回浸对毛细管微尺度流动特性影响的数值模拟研究

刘旭辉^1,2,虞育松³,付拓取^1,2,张伟^1,2,高晨光^1,2,刘瀛龙^1,2,沈岩^1,2,陈君^1,2,王梦^1,2

1.北京控制工程研究所先进空间推进技术实验室，北京 100190;2.北京市高效能及绿色宇航推进工程技术研究中心，北京 100190;3.北京交通大学机械与电子控制工程学院，北京;100044

出版日期:2020-01-20 发布日期:2020-01-20
作者简介:刘旭辉，博士，高级工程师，研究领域为航天器推进技术。E-mail：xhliu99@163.com
基金资助:
“十三五”民用航天项目；北京控制工程研究所先进空间推进技术实验室和北京市高效能及绿色宇航推进工程技术研究中心开放基金（LabASP-2017-16）。

Numerical Simulation of Effects of Heat Soak-Back onMicro-Scale Flow Through a Capillary inADN-Based Thruster

1.Advanced Space Propulsion Laboratory，Beijing Institute of Control Engineering,Beijing 100190,China;2.Beijing Engineering Research Center of Efficient and Green Aerospace Propulsion Technology，Beijing 100190,China;3.School of Mechanical,Electronic and Control Engineering,Beijing Jiaotong University,Beijing 100044,China

Online:2020-01-20 Published:2020-01-20

摘要/Abstract

摘要： 小推力ADN基推力器在工作中，其毛细管内的推进剂容易在壁面传热作用下发生相变，进而影响推力器的正常工作。为了深入理解推进剂在毛细管内的相变和流动特性，采用三维数值模拟方法对毛细管微尺度流动和相变特性进行计算。计算考虑了毛细管与喷注器内的流固耦合传热、推进剂相变过程。推进剂相变采用Lee模型，气液体积分数的求解和气液界面捕捉重构采用VOF-CSF方法。本文首次采用VOF模型耦合Lee相变模型计算了ADN基推进剂在毛细管内的相变过程，并结合气泡空间分布仿真结果得到了质量流量和热回浸温度对流动特性的影响规律。计算结果显示，受到ADN基推进剂的冷却作用，毛细管内壁面温度要略低于外表面。毛细管内的气泡形成于弯管处，其体积沿着毛细管轴向下游逐渐增加，采取散热措施可减少并推迟气泡的形成。随着ADN基推进剂质量流量的降低或下游热回浸温度的增加，毛细管内的气泡均显著增加，且形成区域更接近上游区域。当热回浸温度从800K增加至1100K时，毛细管内的气泡体积从25.6mm³增加至58.7mm³。

关键词: ADN基推进剂;微尺度两相流动;热回浸;相变;流固传热

Abstract: During operation of a small thrust force ADN based thruster, liquid ADN based propellant flowing through a metal capillary commonly undergoes phasechange due to the heat transfer between solid wall and fluid, which can affect the normal operation of the thruster. In this study, 3D CFD method was used to understand the phase change and flow processes in the capillary. The detailed model and methods involved a coupled method for solid/fluid steady heat transfer calculations, the Lee model for liquid-vapor phase transitions, VOF-CSF model for the two-phase volume fraction calculations and surface capture and reconstruction. In this study, the VOF model coupled with Lee model was used to simulate the phase change of the ADN based propellant in the capillary for the first time, and the effects of mass flow rate and the heat soak-back on the flow characteristics were discussed according to the calculated bubble spatial distribution. The results revealed that the temperature on the inner wall of the capillary was slightly lower than that of the outer surface because of the cooling effect of ADN-based propellant. The vapor bubbles formed at the curved section of the transported and grew along the downstream direction of the capillary. The formation processes of bubbles could be impeded and delayed by using the cooling method. With decreasing of the mass flow rate of ADN based propellant or increasing of the temperature due to heat soak-back, the bubble in the capillary increased significantly, and the forming region of bubbles was closer to the upstream region. When the temperature due to heat soak-back increased from 800K to 1100K, the bubble volume in the capillary increased from 25.6mm³ to 58.7mm³.

Key words: ADN based propellant;Micro-scale two-phase flow;Heat soak-back;Phase change;Fluid-solid heat transfer

刘旭辉,虞育松,付拓取,张伟,高晨光,刘瀛龙,沈岩,陈君,王梦. ADN基推力器热回浸对毛细管微尺度流动特性影响的数值模拟研究 [J]. 推进技术, 2020, 41(1): 101-108.

LIU Xu-hui^1,2,YU Yu-song³,FU Tuo-qu^1,2,ZHANG Wei^1,2,GAO Chen-guang^1,2,LIU Ying-long^1,2,SHEN Yan^1,2,CHEN Jun^1,2,WANG Meng^1,2. Numerical Simulation of Effects of Heat Soak-Back onMicro-Scale Flow Through a Capillary inADN-Based Thruster[J]. Journal of Propulsion Technology, 2020, 41(1): 101-108.

参考文献

[1] Hwang C H， Baek S W， Cho S J. Experimental Investigation of Decomposition and Evaporation Characteristics of HAN-Based Monopropellants[J]. Combustion and Flame， 2014， 161(4): 1109-1116.
[2] Kumar Pratim. An Overview on Properties， Thermal Decomposition， and Combustion Behavior of ADN and ADN Based Solid Propellants[J]. Defence Technology， 2018， 14(6): 661-673.
[3] Ide Y， Takahashi T， Iwai K， et al. Potential of ADN-Based Ionic Liquid Propellant for Spacecraft Propulsion[J]. Procedia Engineering， 2015， 99: 332-337.
[4] Anflo K， M?llerberg R. Flight Demonstration of New Thruster and Green Propellant Technology on the PRISMA Satellite[J]. Acta Astronautica， 2009， 65(9): 1238-1249.
[5] 张万生，王晓东，夏连根，等. 绿色ADN液体推进剂应用研究进展[C]. 青岛：中国化学会第八届全国化学推进剂学术会议， 2017.
[6] 姚兆普，苗新，陈君，等. 基于 ADN 基液体推进剂的无毒可贮存空间发动机试验研究[J]. 推进技术， 2014， 35(9): 1247-1252.
[7] 陈君. 二硝酰胺铵（ADN）基液体推进剂催化分解及高压燃烧反应的试验与计算研究[D]. 北京：北京交通大学， 2018.
[8] Asad R， Jitkai C， Feroz K， et al. Characterization and Thrust Measurements from Electrolytic Decomposition of Ammonium Dinitramide (ADN) Based Liquid Monopropellant FLP-103 in MEMS Thrusters[J]. Chinese Journal of Chemical Engineering， 2018， 26(9): 1992-2002，
[9] Yusong Y， Guoxiu L， Tao Z， et al. Effects of Catalyst-bed’s Structure Parameters on Decomposition and Combustion Characteristics of an Ammonium Dinitramide (ADN)-Based Thruster[J]. Energy Conversion and Management， 2015， 106: 566-575.
[10] Wu Suchen， Yu Cheng， Yu Fawen， et al. Lattice Boltzmann Simulation of Co-Existing Boiling and Condensation Phase Changes in a Confined Micro-Space[J]. International Journal of Heat and Mass Transfer， 2018， 126 (B): 773-782.
[11] Mosayeb S， Ali Q R， Martin J B， Branko B. A Numerical Model of Two-Phase Flow at the Micro-Scale Using the Volume-of-Fluid Method[J]. Journal of Computational Physics， 2018， 357: 159-182.
[12] Grétar T， Jiacai L. Direct Numerical Simulations of Flows with Phase Change[R]. AIAA 96-0857.
[13] 孙童童. 微尺度液—汽相变传热的分子动力学模拟[D]. 大连：大连理工大学， 2016.
[14] Saeed S L， Anders C O， S?ren K K. VOF Modelling of Gas-Liquid Flow in PEM Water Electrolysis Cell Micro-Channels[J]. International Journal of Hydrogen Energy，2017， 42(26): 16333-16344，
[15] Gim Y S， Guan H Y， Victoria T. Improved Volume-of-Fluid (VOF) Model for Predictions of Velocity Fields and Droplet Lengths in Microchannels[J]. Flow Measurement and Instrumentation， 2016， 51: 105-115，
[16] Guodong Q， Xinghua W， Weihua C， et al. Development and Validation of Numerical Model of Condensation Heat Transfer and Frictional Pressure Drop in a Circular Tube[J]. Applied Thermal Engineering, 2018， 43: 225-235.
[17] Dae G K， Chul H J， Il S P. Comparison of Numerical Phase-Change Models Through Stefan Vaporizing Problem[J]. International Communications in Heat and Mass Transfer, 2017， 87: 228-236.
[18] Brackbill J U， Kothe D B， Zemach C. A Continuum Method for Modeling Surface Tension[J]. Journal of Computational Physics, 1992， 2: 335-354.
[19] Corral Roque ， Zhi Wang. An Efficient Steady State Coupled Fluid-Solid Heat Transfer Method for Turbomachinery Applications[J]. International Journal of Thermal Sciences， 2018， 130: 59-69.

ADN基推力器热回浸对毛细管微尺度流动特性影响的数值模拟研究

Numerical Simulation of Effects of Heat Soak-Back onMicro-Scale Flow Through a Capillary inADN-Based Thruster

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价