Design and Consideration of Active and Passive Combined Thermal Protection System of Scramjet

Journal of Propulsion Technology ›› 2013, Vol. 34 ›› Issue (12): 1659-1663.

Previous Articles Next Articles

Design and Consideration of Active and Passive Combined Thermal Protection System of Scramjet

School of Energy Science and Engineering, Harbin Institute of Technology, Harbin 150001, China;School of Energy Science and Engineering, Harbin Institute of Technology, Harbin 150001, China;Academy of Fundamental and Interdisciplinary Sciences, Harbin Institute of Technology, Harbin 150001, China;School of Energy Science and Engineering, Harbin Institute of Technology, Harbin 150001, China

Published:2021-08-15

超燃冲压发动机主被动复合热防护系统方案设计思考

鲍文¹,张聪¹,秦江²,于达仁¹

哈尔滨工业大学能源科学与工程学院,黑龙江哈尔滨 150006;哈尔滨工业大学能源科学与工程学院,黑龙江哈尔滨 150006;哈尔滨工业大学基础与交叉科学研究院,黑龙江哈尔滨 150006;哈尔滨工业大学能源科学与工程学院,黑龙江哈尔滨 150006

作者简介:鲍文(1970—),男,博士,教授, 博士生导师,研究领域为高超声速推进主动热防护,发动机控制。E-mail:baowen@hit.edu.cn
基金资助:
国家自然科学基金(51276047);国家杰出青年基金(50925625)。

Abstract

Abstract: For the predicament in thermal protection technology of the Scramjet, a new active and passive combined thermal protection technology which uses the coolant and passive materials to bear the thermal load is put forward. Based on this technology, it is hopeful to achieve the development of high Mach and break through the thermal barrier limiting. And then design connotation and overall design principles are analyzed. Meanwhile, the relationships among the heat load shared by the passive construction, thermal conductivity and thickness of passive materials are discussed. The C/SiC is selected as the passive material to analyze the technology advantages of the active and passive combined thermal protection technology. When the thickness of C/SiC is 4mm, the heat flux could be broadly reduced by 42% at Ma=6.5and equivalence ratio 0.5. 

Key words: Scramjet; Active and passive combined thermal protection; Heat load; C/SiC

摘要： 针对当前超燃冲压发动机热防护技术面临的困境,为了突破更高飞行马赫数下的热障限制,提出了一种采用冷却剂与被动材料共同承担热载荷的主被动复合热防护技术。分析了主被动复合热防护技术的设计内涵及总体设计原则,讨论了被动层承担的热载荷和被动复合材料的导热系数、厚度之间的关系,并以C/SiC作为被动复合材料,对比分析了主被动复合热防护方案的优势。研究表明,当C/SiC厚度为4mm时,大致可将马赫数为6.5,当量比0.5工况下的热流密度降低42%。 

关键词: 超燃冲压发动机;主被动复合热防护;热载荷;C/SiC 

BAO Wen¹, ZHANG Cong¹, QIN Jiang², YU Da-ren¹. Design and Consideration of Active and Passive Combined Thermal Protection System of Scramjet[J]. Journal of Propulsion Technology, 2013, 34(12): 1659-1663.

鲍文,张聪,秦江,于达仁. 超燃冲压发动机主被动复合热防护系统方案设计思考[J]. 推进技术, 2013, 34(12): 1659-1663.

References

[1] Ma Q S, Liu H T, Pan Y, et al.Research Progress on the Application of C/SiC Composites in Scramjet [J].Journal of Inorganic Materials, 2013,8(3):247-255.
[2] Urbano T, Michele G.Approximate Trajectories for Thermal Protection System Flight Tests Mission Design [J].Journal of Spacecraft and Rockets, 2007,4(5).
[3] Wishart D P.Design, Fabrication and Testing of an Actively Cooled Scramjet Propulsion System[R].AIAA 2003-15.
[4] 谢俊,郝英立.超燃冲压发动机热环境与热防护[C].南京:江苏省工程热物理学会第四届学术会议, 2009.
[5] Ulas A, Boysan E.Numerical Analysis of Regenerative Cooling in Liquid Propellant Rocket Engines[J].Aerospace Science and Technology, 2011.
[6] Wennerberg J C, Anderson W E, Haberlen P A, et al.Supercritical Flows in High Aspect Ratio Cooling Channels[R].AIAA 2005-4302.
[7] Fischer A.Future Fuel Heat Sink Thermal Management System Technologies[R].AIAA 2006-4026.
[8] Willard C, Giel D, Raffoul C.Scramjet/Ramjet Design and Integration Trade Studies Using SRHEAT.[R].AIAA 2009-5184.
[9] Bagley S P, Wornat M J.Identification of Five-to Seven-Ring Polycyclic Aromatic Hydrocarbons from the Supercritical Pyrolysis of N-Decane[J].Energy & Fuels, 2011,5(10):4517-4527.
[10] 李志永,李立翰,郑日恒,等.针刺预制体分层对燃烧室C/C-Sic热防护结构的影响[J].推进技术,2011,32(5).(LI Zhi-yong,LI Li-han,ZHENG Ri-heng,et al.Effects of Delamination of Needled Perform on Thermal Insulation of C/C-SiC Chamber[J].Journal of Propulsion Technology,2011,2(5).)
[11] Fellner M, Supancic P.Thermal Shock Failure of Brittle Materials, Fractography of Advanced Ceramics [J].Key Engineering Materials, 2002,3:97-106.
[12] Valdevit L, Vermaak N, Hsu K.Design of Actively Cooled Panels for Scramjets[R].AIAA 2006-8069.

Design and Consideration of Active and Passive Combined Thermal Protection System of Scramjet

超燃冲压发动机主被动复合热防护系统方案设计思考

PDF

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 0

Recommended Articles

Metrics

Comments