高温引气对亚燃冲压燃烧室性能影响的研究

推进技术 ›› 2017, Vol. 38 ›› Issue (12): 2778-2787.

高温引气对亚燃冲压燃烧室性能影响的研究

王亚妹¹,方祥军¹,顾洪斌²,林鹏³,王霄³

北京航空航天大学能源与动力工程学院，北京 100191,北京航空航天大学能源与动力工程学院，北京 100191,中国科学院力学研究所高温气体动力学重点实验室，北京 100190,中国航空工业集团沈阳飞机设计研究所，辽宁沈阳 110035,中国航空工业集团沈阳飞机设计研究所，辽宁沈阳 110035

发布日期:2021-08-15
作者简介:王亚妹，女，博士生，研究领域为冲压发动机燃烧室。

Investigation of Hot Air on Performance of Ramjet Combustor

School of Energy and Power Engineering，Beihang University，Beijing 100191，China,School of Energy and Power Engineering，Beihang University，Beijing 100191，China,LHD，Institute of Mechanics，Chinese Academy of Sciences，Beijing 100190，China,Shenyang Aircraft Design &Research Institute，AVIC，Shenyang 110035，China and Shenyang Aircraft Design &Research Institute，AVIC，Shenyang 110035，China

Published:2021-08-15

摘要/Abstract

摘要： 将高温引气加热煤油的方法、凹腔火焰稳定器和支板喷注器结构应用于亚燃冲压发动机燃烧室中，以提高煤油的点火能力和火焰稳定性。采用有限体积方法求解雷诺平均N-S方程及组分方程，对无引气和有引气时燃烧室内的流场结构进行了数值研究，对比研究了引气温度对燃烧及发动机性能的影响。研究发现，引气温度越高，燃料喷注对流场和温度场的影响越小，燃料分布越均匀；与无引气相比，引入高温气体虽然使总压恢复系数有所降低，但是混合效率、燃烧效率和燃烧室比冲都有提高；特别是有引气(煤油温度T=500K)时，在喷注点后X=480mm处混合效率提高了7.03%并混合完全，在燃烧室出口总压恢复系数降低了5.34%，燃烧效率和比冲分别提高了17.51%和20.29%。引入高温气体加热液态煤油省略了煤油的雾化和汽化过程，增强了燃料与空气掺混，改善了燃烧稳定性，有利于提高燃烧室整体性能。

关键词: 亚燃冲压燃烧室；凹腔/支板结构；高温引气；混合效率；燃烧效率

Abstract: In order to enhance the ability of kerosene’s ignition and flame stability in ramjet combustor， the method that hot air was imported to heat kerosene， cavity flameholder and strut injection structure were applied to ramjet combustor. Reynolds-averaged Navier-Stokes equations with species conservation equation were solved based on the finite volume method. Numerical simulations were conducted to study the flow field in the ramjet combustor with and without hot air imported， and the effects of the air temperature on the combustion and engine performance were compared. It is found that the influence of fuel injection on flow field and temperature field is smaller and the fuel distribution is more uniform when the temperature of hot air is higher. Compared with no hot air imported， although the total pressure loss increase in some extent， the fuel-air mixing efficiency， combustion efficiency and the specific impulse of the combustor are improved in a remarkable extent with hot air imported; especially with hot air imported(kerosene temperature T=500K)， mixing efficiency increased by 7.03% and mixed completely at the location of X=480mm after the injection point， total pressure recovery coefficient reduced by 5.34%， combustion efficiency and specific impulse increased by 17.51% and 20.29% respectively at the combustor exit. Due to the hot air imported to heat kerosene， the process of atomization and vaporization of kerosene is omitted， which enhances the mixing of fuel and air and improves the stability of combustion. Therefore， it is good for improving the combustor performance when hot air is imported to heat kerosene in ramjet combustor.

Key words: Ramjet combustor；Cavity/strut structure；Hot air；Mixing efficiency；Combustion efficiency

王亚妹,方祥军,顾洪斌,林鹏,王霄. 高温引气对亚燃冲压燃烧室性能影响的研究[J]. 推进技术, 2017, 38(12): 2778-2787.

WANG Ya-mei¹,FANG Xiang-jun¹,GU Hong-bin²,LIN Peng³,WANG Xiao³. Investigation of Hot Air on Performance of Ramjet Combustor[J]. Journal of Propulsion Technology, 2017, 38(12): 2778-2787.

参考文献

[1] 刘兴洲. 飞航导弹动力装置[M]. 北京: 国防工业出版社, 1992.
[2] Bouchez M, Roudakov A S, Kopchenov V I, et al. French-Russian Analysis of Kholod Dual-Mode Ramjet Flight Experiments[R]. AIAA 2005-3320.
[3] Ben-Yakar A, Hanson R K. Cavity Flame-Holders for Ignition and Flame Stabilization in Scramjets: an Overview[J]. Journal of Propulsion and Power, 2001,17(4): 869-878.
[4] Gu H, Chen L, Wang D, et al. Experimental Investigation on Coupling Characteristics of Cavity Flameholder and Strut Jet[R]. AIAA 2012-5961.
[5] Denman Z J, Brieschenk S, Veeraragavan A, et al. Experimental Design of a Cavity Flameholder in a Mach 8 Shape-Transitioning Scramjet[R]. AIAA 2014-2953.
[6] Losurdo M, Bruno C, Patrignani L. Numerical Simulations of Trapped Vortex Combustors. Feasibility Study of TVC Integration in Traditional GT Combustion Chambers [R]. AIAA 2006-5140.
[7] 谭建国, 黄国庆, 潘余, 等. 凹腔型亚燃冲压发动机燃烧效率研究[J]. 航空动力学报, 2011, 26(6):1415-1419.
[8] 邓远灏, 钟华贵, 徐华胜, 等. 亚燃冲压模型燃烧室高空负压试验[J]. 推进技术, 2012, 33(1): 69-72. (DENG Yuan-hao, ZHONG Hua-gui, XU Hua-sheng, et al. Experiment of Ramjet Model Combustor under High Altitude and Low Pressure Condition [J]. Journal of Propulsion Technology, 2012, 33(1): 69-72.)
[9] Gerlinger P, Stoll P, Markus K, et al. Numerical Investigation of Mixing and Combustion Enhancement in Supersonic Combustors by Strut Induced Streamwise Vorticity[J]. Aerospace Science and Technology, 2008, 12(4): 159-168.
[10] Fureby C, Nordin-Bates K, Petterso K, et al. A Computational Study of Supersonic Combustion in Strut Injector and Hypermixer Flow Fields[J]. Proceedings of the Combustion Institute, 2015, 35(2):2127-2135.
[11] Hsu K Y, Carter C D, Gruber M R, et al. Experimental Study of Cavity-Strut Combustion in Supersonic Flow[J]. Journal of Propulsion and Power, 2010, 26(6):1237-1246.
[12] 冮强, 周乐仪, 覃正, 等. 液体碳氢燃料超燃冲压发动机支板凹槽稳焰技术试验[J] . 推进技术, 2011, 32(5): 680-683. (GANG Qiang, ZHOU Le-yi, TAN Zheng, et al. Experimental Investigation of Strut-cavity Flameholer Technology in Liquid Hydrocarbon Fueled Scramjet Combustor[J]. Journal of Propulsion Technology, 2011, 32(5): 680-683.)
[13] Shih T H, Liou W W, Shabbir A, et al. A New k-ε Eddy Viscosity Mode for High Reynolds Number Turbulent Flow[J]. Computers and Fluids, 1995, 24(3): 227-238.
[14] Yakhot V, Orsszag S A, Thangam S, et al. Development of Turbulence Models for Shear Flows by a Double Expansion Technique[J]. Physics of Fluids, 1992, 4(7): 1510-1520.
[15] 李庆. 基于凹腔火焰稳定器的亚燃冲压发动机燃烧室点火过程研究[D]. 南京:国防科技大学, 2010.
[16] Liu G. Numerical Investigation on the Supersonic Combustion of Liquid Kerosene in a Dual-Staged Strut Based Scramjet Combustor[R]. AIAA 2014-3665.
[17] Rust B. An Improved Lobed Strut Injector Concept for Supersonic Combustion[R]. AIAA 2010-6962.　　　　　　　　　　　　　*　收稿日期:2016-08-14；修订日期:2016-10-10。作者简介:王亚妹,女,博士生,研究领域为冲压发动机燃烧室。E-mail: wangyamei2010@126.com(编辑:张荣莉)