缝槽平板振动气膜冷却数值仿真研究

推进技术 ›› 2018, Vol. 39 ›› Issue (12): 2806-2812.

缝槽平板振动气膜冷却数值仿真研究

梁俊龙¹,任加万²,张贵田¹

西北工业大学燃烧、流动和热结构国家级重点实验室，陕西西安 710072,西安航天动力研究所，陕西西安 710100,西北工业大学燃烧、流动和热结构国家级重点实验室，陕西西安 710072

发布日期:2021-08-15

Numerical Simulation of Film Cooling on Vibrating Slot Plate

National Key Laboratory of Combustion，Flow and Thermo-Structure，Northwestern Polytechnical University， Xi’an 710072，China,Xi’an Aerospace Propulsion Institute，Xi’an 710100，China and National Key Laboratory of Combustion，Flow and Thermo-Structure，Northwestern Polytechnical University， Xi’an 710072，China

Published:2021-08-15

摘要/Abstract

摘要： 为了分析缝槽平板振动气膜冷却传热规律，采用基于Reynolds Averaged Navier-Stokes(RANS)和Detached-Eddy Simulation (DES)的CFD动网格仿真分析方法，研究了不同振动频率、不同振幅、不同吹风比及剪切涡结构振动的绝热壁面有效温比。结果表明:(1)在低频(f=100Hz)下，振动有利于提高换热面绝热壁面有效温比；但在高频(f=10kHz)下，振动降低了换热面绝热壁面有效温比。(2)相比频率，振幅对绝热壁面有效温比影响更大；在中频(f=1kHz)下，振动绝热壁面有效温比小于稳态绝热壁面有效温比；不同吹风比(M=0.7， 1.2， 1.9)对绝热壁面有效温比影响趋势基本一致。(3)相比基于RANS的振动仿真方法，基于DES的振动仿真方法能更详细地模拟混合层剪切涡结构流场信息，能更好地反映剪切涡结构对壁面换热效果的影响。

关键词: 缝槽平板振动；绝热壁面有效温比；RANS仿真分析；DES仿真分析；气膜冷却

Abstract: In order to identify the heat transfer of slot plat film cooling under slot vibrating conditions， the adiabatic film effectiveness over a slot plat at different vibration frequencies， vibration amplitudes， blow ratios and shear vortex of the mixing layer was analyzed using CFD dynamic meshing approach based on Reynolds averaged Navier-Stokes(RANS) and Detached-Eddy Simulation(DES). The results show that: (1)Under low vibration frequency (f=100Hz)， the slot vibration increases the adiabatic film effectiveness of heat transfer surface; While under high vibration frequency (f=10kHz)， the slot vibration decreases the adiabatic film effectiveness of heat transfer surface. (2)Under general vibration frequency (f=1kHz)， the adiabatic film effectiveness is weakened by vibration， what’s more， the adiabatic film effectiveness is affected more significantly by vibration amplitude than by vibration frequency. The different blow ratios(M=0.7， 1.2， 1.9) keep almost the same influence on the adiabatic film effectiveness. (3)Compared to RANS method， DES approach performs more efficiently in predicting structure of shear vortex， and better reflects of shear vortex on adiabatic film effectiveness under slot vibration condition.

Key words: Slot plat vibration；Adiabatic film effectiveness；Reynolds averaged Navier-Stokes simulation；Detached-Eddy simulation；Film cooling

梁俊龙,任加万,张贵田. 缝槽平板振动气膜冷却数值仿真研究[J]. 推进技术, 2018, 39(12): 2806-2812.

LIANG Jun-long¹,REN Jia-wan²,ZHANG Gui-tian¹. Numerical Simulation of Film Cooling on Vibrating Slot Plate[J]. Journal of Propulsion Technology, 2018, 39(12): 2806-2812.

参考文献

[1] 葛绍岩, 刘登瀛, 陈靖中, 等. 气膜冷却[M]. 北京:科学出版社, 1985.
[2] Toshihiko Takahashi, Ken-ichi Funazaki, Hamidon Bin Salleh, et al. Assessment of URANS and DES for Prediction of Leading Edge Film Cooling[R]. ASME GT-2012-031008.
[3] Carlos A Cruz, Fernando Raffan, Christopher Cadou, et al. Slot Film Cooling: LES and Heat Transfer Measurements[R]. AIAA 2007-926.
[4] 刘宁, 孙纪宁. 基于大涡模拟分析气膜冷却的湍流场[J]. 航空动力学报, 2010, 25(9): 1971-1977.
[5] 周志翔, 刘存良, 张宗卫, 等. 主流湍流度对涡轮导向叶片气膜冷却特性影响的实验[J]. 航空动力学报, 2014, 29(6): 1279-1286.
[6] 杨彬, 徐国强, 吴宏伟. 旋转状态下气膜冷却换热特性的实验研究[J]. 航空学报, 2009, 30(10): 1809-1815.
[7] 朱惠人, 原和朋, 周志强, 等. 几何结构对后台阶缝隙气膜冷却效率的影响[J]. 推进技术, 2006, 27(4):312-315. (ZHU Hui-ren, YUAN He-peng, ZHOU Zhi-qiang, et al. Effect of Geometry of Back-Step Slots on Film Cooling[J]. Journal of Propulsion Technology, 2006, 27(4): 312-315.)
[8] 孙瑞嘉, 杨卫华, 贺宜红, 等. 不同叶片尾缘结构对流换热特性实验[J]. 推进技术, 2011, 32(4): 485-490. (SUN Rui-jia, YANG Wei-hua, HE Yi-hong, et al. Experiment on Convective Coefficient of Different Turbine Blade Trailing Edges[J]. Journal of Propulsion Technology, 2011, 32(4): 485-490.)
[9] 刘友宏, 任浩亮. 气膜孔倾角对层板隔热屏冷却性能影响[J]. 推进技术, 2016, 37(2): 281-288. (LIU You-hong, REN Hao-liang. Effects of Film Cooling Hole Angles of Inclination on Cooling Performance of Lamilloy Heat Shield[J]. Journal of Propulsion Technology, 2016, 37(2): 281-288.)
[10] Cheng Lin, Qiu Yan. Complex Heat Transfer Enhancement by Fluid Induced Vibration[J]. Journal of Hydrodynamics, 2003, 1: 84-89.
[11] Kenan Yakut, Bayram Sahin. Flow-Induced Vibration Analysis of Conical Rings Used for Heat Transfer Enhancement in Heat Exchangers[J]. Applied Energy, 2004, 78(3): 273-288.
[12] 王一平, 卢艳华, 朱丽, 等. 振动平板的传热性能实验[J]. 天津大学学报, 2010, 43(6): 549-552.
[13] 林宗虎. 强化传热及其工程应用[M]. 北京:机械工业出版社, 1987.
[14] 林宗虎, 汪军, 李瑞阳. 强化传热技术[M]. 北京:化学工业出版社, 2007.
[15] 葛利顺, 王宏光, 沈佳欢. 振动平板气膜冷却的数值分析[J]. 动力工程学报, 2015, 35(9): 722-727.
[16] 朱志文, 王宏光. 管内振动壁面射流流场的数值模拟[J]. 上海理工大学学报, 2015, 37(2): 110-114.
[17] Burdet Andre, Abhari Reza S. Influence of near Hole Pressure Fluctuation on the Thermal Protection of a Film-Cooled Flat Plate[J]. Journal of Heat Transfer, 2009, 131(2): 1-11.
[18] Babaee Hessam, Wan Xiaoliang, Acharya Sumanta. Effect of Uncertainty in Blowing Ratio on Film Cooling Effectiveness[J]. Journal of Heat Transfer, 2014, 136(3).
[19] 任加万, 谭永华, 吴宝元. 瞬态热冲击缝槽气膜冷却传热实验及仿真研究[J]. 推进技术, 2016, 37(9):1703-1712. (REN Jia-wan, TAN Yong-hua, WU Bao-yuan. Experimental Investigation and CFD Simulation of Heat Transfer of Slot Film Cooling under Transient Thermal Shock Conditions[J]. Journal of Propulsion Technology, 2016, 37(9): 1703-1712.)
[20] 王军雷, 吴金星, 丁林, 等. 完全湍流剪切层对圆柱涡激振特性的影响[J]. 哈尔滨工业大学学报, 2017, 49(1): 178-183.
[21] 陈江涛, 张培红, 周乃春, 等. 基于SA湍流模型的DES方法应用[J]. 北京航空航天大学学报, 2012, 38(7): 905-909.　　　　　　　　　　　　　　收稿日期:2017-10-23；修订日期:2017-12-15。通讯作者:梁俊龙,男,博士生,研究员,研究领域为航空宇航推进理论与工程。E-mail: liangjl067@163.com(编辑:朱立影)