增广预测模型的航空发动机多变量约束预测控制

doi:10.13675/j.cnki. tjjs. 180578

推进技术 ›› 2019, Vol. 40 ›› Issue (11): 2579-2586.DOI: 10.13675/j.cnki. tjjs. 180578

增广预测模型的航空发动机多变量约束预测控制

杨思幸¹,鲁峰¹,黄金泉¹

南京航空航天大学能源与动力学院江苏省航空动力系统重点实验室

发布日期:2021-08-15
作者简介:杨思幸，硕士生，研究领域为航空发动机控制。E-mail：ysxilmf717@163.com

Multivariable Constrained Model Predictive Control ofAero-Engine Based on Augmented Predictive Model

Jiangsu Province Key Laboratory of Aerospace Power System,College of Energy and Power Engineering, Nanjing University of Aeronautics and Astronautics,Nanjing 210016,China

Published:2021-08-15

摘要/Abstract

摘要： 针对模型不匹配导致的模型预测控制性能下降的问题，提出了一种基于增广预测模型的航空发动机多变量约束预测控制器设计方法。在现有发动机状态空间模型基础上，将指令跟踪误差与系统状态的变化量增广为状态向量，设计增广预测模型以消除稳态跟踪误差，以控制量所需能量与模型预测输出误差最小为目标，利用带约束的序列二次规划（SQP）算法在线滚动优化控制变量。通过某型涡扇发动机非线性部件级模型的包线内不同状态下仿真分析，结果表明，控制系统无稳态误差，调节时间<2s，有效提高了发动机控制品质，实现了对输出量的限制管理。

关键词: 航空发动机;多变量控制;预测控制;稳态误差

Abstract: To solve the performance degradation of model predictive control caused by model mismatch,a design method of multivariable constrained predictive controller was proposed based on the augmented predictive model for aero-engines. Based on ·the existed state space model, the command tracking errors and variations of system states were augmented as state vector to eliminate the tracking errors. Then, aiming at taking the energy required by control variables and the predictive tracking errors to minimum, the receding horizon optimization of the control variables can be realized online using sequential quadratic programming method. Finally, the controller was applied to the nonlinear component-level-model of a certain turbofan engine where various engine states in full envelope were examined and analyzed. Simulation results show that the settling time of the control system is less than 2 seconds and the steady state error is zero. The quality of engine control is improved effectively and the constraint management of output is achieved.

Key words: Aero engine;Multivariable control;Predictive control;Steady state error

杨思幸,鲁峰,黄金泉. 增广预测模型的航空发动机多变量约束预测控制[J]. 推进技术, 2019, 40(11): 2579-2586.

YANG Si-xing¹,LU Feng¹,HUANG Jin-quan¹. Multivariable Constrained Model Predictive Control ofAero-Engine Based on Augmented Predictive Model[J]. Journal of Propulsion Technology, 2019, 40(11): 2579-2586.

参考文献

[1] Csank J, Ryan D M， Jonathan S L， et al. Control Design for a Generic Commercial Aircraft Engine[R]. AIAA2010-6629.
[2] Jafari S， Montazerigh M. Evolutionary Optimization for Gain Tuning of Jet Engine Min-Max Fuel Controller[J]. Journal of Propulsion and Power， 2011， 27(5): 1015-1023.
[3] Du X， Richter H， Guo Y. Multivariable Sliding-Mode Strategy with Output Constraints for Aeroengine Propulsion Control[J]. Journal of Guidance， Control and Dynamics， 2016， 39(7): 1631-1642.
[4] Qi Y W， Bao W， Chang J T. State-Based Switching Control Strategy with Application to Aero-Engines Safety Protection[J]. Journal of Aerospace Engineering， 2015， 28(3): 1-11.
[5] Imani A， Montazeri-Gh M. Improvement of Min-Max Limit Protection in Aircraft Engine Control: An LMI Approach[J]. Aerospace Science and Technology， 2017， 68， 212-222.
[6] 席裕庚，李德伟，林姝. 模型预测控制-现状与挑战[J]. 自动化学报， 2013， 39(3): 222-236.
[7] Decastro J A. Rate-Based Model Predictive Control of Turbofan Engine Clearance[J]. Journal of Propulsion and Power， 2007， 23(4): 804-813.
[8] Eren U， Prach A， Ko?er B B， et al. Model Predictive Control in Aerospace Systems: Current State and Opportunities[J]. Journal of Guidance， Control and Dynamics， 2017， 40(7): 1541-1566.
[9] Seok Jinwoo ， Kolmanovsky Ilya ， Girard Anouck. Coordinated Model Predictive Control of Aircraft Gas Turbine Engine and Power System[J]. Journal of Guidance， Controland Dynamics， 2017， 40(10): 2538-2555.
[10] Montazeri-Gh M， Rasti A， Imani A. Comparison of Model Predictive Controller and Min-Max Approach for Aircraft Engine Fuel Control[C]. Shiraz：International Conference on Control， Instrumentation， and Automation. 2017.
[11] Richter H. Advanced Control of Turbofan Engines[M]. New York: Springer， 2012.
[12] Saluru D C， Yedavalli R K. Fault Tolerant Model Predictive Control of a Turbofan Engine Using C-MAPSS40k[R]. AIAA2013-0128.
[13] 肖玲斐，黄向华. 涡轴发动机自适应非线性预测控制[J]. 航空动力学报， 2012， 27(5):1194-1200.
[14] 杜宪，郭迎清，陈小磊. 基于非线性模型预测控制方法的航空发动机约束管理[J]. 航空动力学报， 2015， 30(7): 1766-1771.
[15] 彭靖波，谢寿生，白云，等. 航空发动机模糊自适应广义预测解耦控制[J]. 空军工程大学学报， 2009， 10(1):5-8.
[16] 苗卓广，谢寿生，王磊，等. 航空发动机多模型预测滑模控制[J]. 推进技术， 2012， 33(3):391-395.
[17] 席裕庚. 预测控制[M]. 北京：国防工业出版社， 2013.
[18] 姜锐. 航空发动机线性变参数控制方法研究[D]. 南京：南京航空航天大学， 2014.
[19] 乔洪信，樊思齐，杨立，等. 航空发动机状态空间模型约束预测控制[J]. 推进技术， 2005， 26(6): 548-551.
[20] 张日东，王树青，李平. 一类非线性系统的扩展状态空间预测扩展[J]. 控制与决策， 2005， 20(7): 807-810.
[21] 赵连春，马丁利 J D. 飞机发动机控制：设计、系统分析和健康监视[M]. 北京：航空工业出版社， 2012.

增广预测模型的航空发动机多变量约束预测控制

Multivariable Constrained Model Predictive Control ofAero-Engine Based on Augmented Predictive Model

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价